In my plans, the fuel line is one piece from the tank to the fuel valve. I
used a rubber grommet in the 1 inch hole.
Rene'
801-721-6080
-----Original Message-----
From: owner-rv10-list-server@matronics.com
[mailto:owner-rv10-list-server@matronics.com] On Behalf Of Lenny Iszak
Sent: Monday, August 25, 2008 8:19 PM
To: rv10-list@matronics.com
Subject: Old fuse, new plans...
I've been scratching my had trying to figure out how am I going to screw the
6D bulkhead fittings into a 1 inch hole , where the fuel line exits the
fuselage at the wing root.
I just looked at the plans on Tim's site and as it turns out I have the
Revision#2 plans and a Rev #0 fuselage. Even my Fuel selector bracket is
different.
Do any of you know why this was changed?
The Rev 2 plans also show an extension rod for the fuel selector.
I guess at this point I should just print Tim's plans and use those.
Regards,
Lenny
#40803
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p 0594#200594
