... fine tooth saw type blade. I was cutting down in to the arc of
the window and it went "pop" with about an 8" crack.
the wheels were supplied with the finish kit... don't remember the bag
number.
as long as you've got adequate air pressure, the cutoff wheels work
very well... no need to reinvent the "wheel" on this one.
On Nov 19, 2009, at 3:23 PM, Bill Mauledriver Watson wrote:
> >
>
> 2 questions of academic interest only
> - what multimaster blade did you use - a fine tooth saw type or the
> tile cutter type of abrasive blade?
> - I've never found the Vans supplies cutoff wheels - where are they?
>
> Curious Bill
>
> do not archive
>
>
> Jeff Carpenter wrote:
>> >
>>
>> I used the Multimaster on the first window I tried to trim and it
>> snapped in half. I strongly suggest that you use the cut off
>> wheels that Vans provided to make the initial trim on the window
>> and sand it down for the final fit.
>>
>> Jeff Carpenter
>> 40304
>> You'd think I've redone all my windows at this point... but so far,
>> only two.
>>
>>
>
>
