Today's Message Index:
----------------------
1. 05:36 AM - 403 Inputs (Pete Howell)
2. 03:05 PM - Re: How to wire switch (Speedy11@aol.com)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
--> AeroElectric-List message posted by: "Pete Howell" <pete.howell@gecko-group.com>
Hi Brian,
I can't help you with the math behind the components, but I do have
one way to do the packaging. I used a 15 pin-sub connector as the
base for the device. I soldered one lead of the resistor and cap
togecther and then bent it into a "U" shape and crimped sockets on
each end. Then I covered each resistor/cap pair (isolator) in heat
shrink and put it in the connector. When all the isolators were in
place, more heat shrink over the entire thing. Incoming and
outgoing wire comes into the mating connector and get d-sub pins.
Drop me an e-mail and I will send some pics.
Pete
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: How to wire switch |
--> AeroElectric-List message posted by: Speedy11@aol.com
Thanks to all who responded. I will follow your instructions, all.
Stan
Do Not Archive
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|