---------------------------------------------------------- AeroElectric-List Digest Archive --- Total Messages Posted Fri 05/12/06: 2 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 05:36 AM - 403 Inputs (Pete Howell) 2. 03:05 PM - Re: How to wire switch (Speedy11@aol.com) ________________________________ Message 1 _____________________________________ Time: 05:36:38 AM PST US From: "Pete Howell" Subject: AeroElectric-List: 403 Inputs --> AeroElectric-List message posted by: "Pete Howell" Hi Brian, I can't help you with the math behind the components, but I do have one way to do the packaging. I used a 15 pin-sub connector as the base for the device. I soldered one lead of the resistor and cap togecther and then bent it into a "U" shape and crimped sockets on each end. Then I covered each resistor/cap pair (isolator) in heat shrink and put it in the connector. When all the isolators were in place, more heat shrink over the entire thing. Incoming and outgoing wire comes into the mating connector and get d-sub pins. Drop me an e-mail and I will send some pics. Pete ________________________________ Message 2 _____________________________________ Time: 03:05:49 PM PST US From: Speedy11@aol.com Subject: AeroElectric-List: Re: How to wire switch --> AeroElectric-List message posted by: Speedy11@aol.com Thanks to all who responded. I will follow your instructions, all. Stan Do Not Archive