Today's Message Index:
----------------------
1. 11:02 AM - Ebay #9723825338 (Jerry Grimmonpre)
2. 12:53 PM - Re: Ebay #9723825338 (Robert L. Nuckolls, III)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Ebay #9723825338 |
--> AeroElectric-List message posted by: "Jerry Grimmonpre" <jerry@mc.net>
Bob ...
Is this Gilchrist coax stripper suitable for RG-400? It has three blades
but does not list RG-400. Gilchrist will not respond to questions.
Thanks ...
Jerry Grimmonpre'
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Ebay #9723825338 |
--> AeroElectric-List message posted by: "Robert L. Nuckolls, III" <nuckollsr@cox.net>
At 12:53 PM 5/13/2006 -0500, you wrote:
>--> AeroElectric-List message posted by: "Jerry Grimmonpre" <jerry@mc.net>
>
>Bob ...
>Is this Gilchrist coax stripper suitable for RG-400? It has three blades
>but does not list RG-400. Gilchrist will not respond to questions.
>Thanks ...
>Jerry Grimmonpre'
Yes, that's the one I give away at the seminars. It's
ADJUSTABLE. It will probably work for RG-400 as received
but you can check the results of the cuts carefully and
adjust as needed for optimization.
Bob . . .
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|