Today's Message Index:
----------------------
1. 10:51 PM - Magneto P leads (DEAN PSIROPOULOS)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
--> AeroElectric-List message posted by: "DEAN PSIROPOULOS" <dean.psiropoulos@verizon.net>
I'm wondering about connecting the P leads at the magneto. Looking at the
top of the (Slick) magneto I removed the nut and star washer and found an
insulating fiber washer. Looking under the washer, there is the threaded
stud which projects from a piece of white plastic that is in turn surrounded
by a shiny piece of metal that looks like a large nut. My question has to
do with grounding the P lead out on magneto which is what lectric Bob
recommends for lowest system noise. I assume that the fiber washer is there
to keep the P lead terminal from grounding the threaded stud to the "shiny
metal nut" that surrounds the plastic that the stud projects out of. If so,
can I use two ring terminals on the coax, one with a much larger ring placed
under the fiber washer which will serve as the return grounding path and
then place a smaller ring terminal (connected to the other wire in the
coax)on top of the fiber washer (which is on top of the larger ring terminal
contacting the shiny metal nut) under the nut that goes on the stud and not
have to worry about magneto grounding somewhere else on the engine? I'm
just trying to not have to strip a whole bunch of shield off the P lead for
grounding at a separate location and this looks like it should work but I
know nothing about magnetos so I'm not sure if my hypothesis is correct. I
hope you can decipher what I trying to say. Thanks.
Dean Psiropoulos
RV-6A N197DM
Stringing wire (still)
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|