Today's Message Index:
----------------------
1. 12:11 PM - Bendix IN-224A Pinout or wiring diagram (KELLY-CRAPSE, RICHARD W (RICK), ATTGNS)
2. 06:57 PM - Re: Molex wire splice recall (Joemotis@aol.com)
3. 07:52 PM - Re: Bendix IN-224A Pinout or wiring diagram (Ron Quillin)
4. 09:23 PM - Printed circuits (John F. Herminghaus)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Bendix IN-224A Pinout or wiring diagram |
I need a pinout for the IN-224A that we are trying to use with a KX-170B
and KNS-80. Owner did not have an indicator. Seems the ocean swallowed
his last plane. Anybody have that pinout?
Thanks,
Rick
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Molex wire splice recall |
If you do not tug test a crimped connection before putting it in service,
you will have a failure over time, guaranteed.
My personal reflection on this is as we get older, that old nemesis
arthritis starts to kick in and we just do not squeeze the Sta-Kon pliers with
the
crushing grip of our youth.
Joe Motis
No Archivos, eh!
**************It's only a deal if it's where you want to go. Find your travel
deal here.
(http://information.travel.aol.com/deals?ncid=aoltrv00050000000047)
Message 3
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Bendix IN-224A Pinout or wiring diagram |
At 11:58 8/21/2008, you wrote:
>I need a pinout for the IN-224A that we are trying to use with a KX-170B
>and KNS-80.
Verify IN224A and not IN244A.
I have 244.
Ron Q.
Message 4
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Printed circuits |
Bob,
I know that this subject has been discussed before, but can't find it.
In short, what do you recommend to clean printed circuit boards after
assembly?
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|