Today's Message Index:
----------------------
1. 05:49 AM - Bulkhead connector (Richard Girard)
2. 07:36 AM - Re: Bulkhead connector (Robert L. Nuckolls, III)
3. 11:48 AM - Re: Bulkhead connector (Richard Girard)
4. 06:59 PM - Re: Bulkhead connector (edleg)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Bulkhead connector |
Folks, Sorry to weigh in on this so late, but I found the nifty PL 259
chassis connector (on the right in the photo) at Radio Shack during a parts
run on Friday. Part number is 278-0201. I already had a BNC cable so I
bought an adapter (PN 278-121), too.
Rick Girard
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Bulkhead connector |
At 07:39 AM 5/2/2010, you wrote:
>Folks, Sorry to weigh in on this so late, but I found the nifty PL
>259 chassis connector (on the right in the photo) at Radio Shack
>during a parts run on Friday. Part number is 278-0201. I already had
>a BNC cable so I bought an adapter (PN 278-121), too.
I guess I'm disconnected from the thread. How are
you using these parts?
Bob . . .
Message 3
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Bulkhead connector |
Bob, I'm going to solder a piece of 3/32" brazing rod into the center lug of
the PL 259 chassis mount (the lug is drilled out to let it slip in for a
good mechanical attachment once the soldering is done), trim to appropriate
length and use it as an antenna for my hand held.
Rick
On Sun, May 2, 2010 at 9:23 AM, Robert L. Nuckolls, III <
nuckolls.bob@aeroelectric.com> wrote:
> nuckolls.bob@aeroelectric.com>
>
>
> At 07:39 AM 5/2/2010, you wrote:
>
>> Folks, Sorry to weigh in on this so late, but I found the nifty PL 259
>> chassis connector (on the right in the photo) at Radio Shack during a parts
>> run on Friday. Part number is 278-0201. I already had a BNC cable so I
>> bought an adapter (PN 278-121), too.
>>
>
> I guess I'm disconnected from the thread. How are
> you using these parts?
>
> Bob . . .
>
>
Message 4
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Bulkhead connector |
Once you get the piece of brazing rod soldered in, and it cools down, you might
want to pack that area around the base of the antenna full of RTV to help make
it watertight.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=296528#296528
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|