Today's Message Index:
----------------------
1. 05:26 AM - Re: Off Topic - Looking for geared AC motor (dfritzj)
2. 09:04 AM - Re: Off Topic - Looking for geared AC motor (Neal George)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Off Topic - Looking for geared AC motor |
I've been using such a geared motor for years to turn a large barbecue rotisserie
(good for a pig up to 110 pounds). What I used appears to be a mill or lathe
electric feed motor. It's plenty strong and turns at about 10 RPM. You may be
able to find something similar that turns a little quicker at a surplus shop.
Dan
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Off Topic - Looking for geared AC motor |
Jerry -
Lots to choose from here:
http://www.surpluscenter.com/electric.asp
neal
-----Original Message-----
From: owner-aeroelectric-list-server@matronics.com
[mailto:owner-aeroelectric-list-server@matronics.com] On Behalf Of jerb
Sent: Friday, December 24, 2010 11:11 PM
Subject: AeroElectric-List: Off Topic - Looking for geared AC motor
Hey folks there are a lot of resources on these list. Anyone have or
know of a source for an surplus (cheap is good) geared down 120V AC
motor of 1/4-1/3 HP. Inline or right angle gear box will work - need
a shaft output of around 20-43 (desired) or 80-100 RPM. This in not
for an aviation orientated project. I can't justify the cost of a
new unit for its intended use.
If so please email direct. Thanks,
jerryb
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|