---------------------------------------------------------- AeroElectric-List Digest Archive --- Total Messages Posted Wed 04/04/12: 6 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 09:02 AM - Re: LED WigWag with B&C SSF-1 (gregmchugh) 2. 09:41 AM - Re: Re: LED WigWag with B&C SSF-1 (Robert L. Nuckolls, III) 3. 10:44 AM - Next generation wig-wag controller for LED lamps (Robert L. Nuckolls, III) 4. 12:11 PM - Re: Troubleshooting Field Breaker (Jim P) 5. 06:27 PM - Trade my 5a CB's for 7.5a (jonlaury) 6. 09:04 PM - Next generation wig-wag controller for LED lamps (Michael Ashura) ________________________________ Message 1 _____________________________________ Time: 09:02:38 AM PST US Subject: AeroElectric-List: Re: LED WigWag with B&C SSF-1 From: "gregmchugh" I have been considering the Perihelion Wig-Wag to use with Teledyne LED Landing/Taxi lights. I will be interested in other options for the Wig-Wag module... Wig-Wag http://www.periheliondesign.com/wigwagmnl.htm LED Lights http://www.aircraftspruce.com/catalog/elpages/teledynelandinglight.php Greg McHugh Read this topic online here: http://forums.matronics.com/viewtopic.php?p=370030#370030 ________________________________ Message 2 _____________________________________ Time: 09:41:07 AM PST US From: "Robert L. Nuckolls, III" Subject: Re: AeroElectric-List: Re: LED WigWag with B&C SSF-1 At 11:01 AM 4/4/2012, you wrote: > >I have been considering the Perihelion Wig-Wag to use with Teledyne >LED Landing/Taxi lights. I will be interested in other options for >the Wig-Wag module... That one works and is, no doubt, suited to LED lighting fixtures Bob . . . ________________________________ Message 3 _____________________________________ Time: 10:44:17 AM PST US From: "Robert L. Nuckolls, III" Subject: AeroElectric-List: Next generation wig-wag controller for LED lamps At 06:19 PM 3/30/2012, you wrote: > >Bob, can I wire two LED landing and taxi lights per Page 3.0 (Ref DE >12/15/11) but using a single switch (already installed and labeled >in unflown RV-6) as shown on Page 3.0 from 2003? Thank you Give me a few days on this. It occurs to me that I've been twisting what WAS a good system for incandescent lamps into a pretzel in search of the elegant solution for LED lamps. --------------------------------------- As promised, I spend some time considering the ingredients that go into an alternative recipe for success. I began with the following design goals: All solid state Stand off 20V bus for 1 second or more Simple switching that does NOT require progressive transfer switch to achieve OFF/WW/ON operation of lights. Suitable for LED landing light fixtures Minimum parts count. While plying the asphalt between here and Wichita I sifted through the pieces and parts. Here's a first pass at the idea. http://tinyurl.com/6t7zry2 This device could be fabricated from surface mount parts and totally contained inside a 15-pin, d-sub housing for an end product that looks like this. Emacs! This circuit also lends itself to a DIY effort with thru-hole parts mounted on a perf board. Mike, if you already have a 2-10 switch installed, it can be wired to function with this controller. Bob . . . ________________________________ Message 4 _____________________________________ Time: 12:11:05 PM PST US Subject: AeroElectric-List: Re: Troubleshooting Field Breaker From: "Jim P" Thanks Joe, I'll run that test when I'm back out at the airport. Read this topic online here: http://forums.matronics.com/viewtopic.php?p=370039#370039 ________________________________ Message 5 _____________________________________ Time: 06:27:54 PM PST US Subject: AeroElectric-List: Trade my 5a CB's for 7.5a From: "jonlaury" I just purchased and installed two 5a breakers where 7.5a were called for. Can't return them so if you have 2x7.5a and need 5's, raise your hand. I have the new smaller, green ones from Klixon Thanks, John see http://www.aircraftspruce.com/catalog/elpages/klixon2tc5.php Read this topic online here: http://forums.matronics.com/viewtopic.php?p=370061#370061 ________________________________ Message 6 _____________________________________ Time: 09:04:53 PM PST US From: Michael Ashura Subject: AeroElectric-List: Next generation wig-wag controller for LED lamps Bob, thank you for the schematic. I guess this is the part where the "education" part comes in with my project. The "U" devices already have my curiosity... BTW, how does a person see the picture where the Emacs! occurs? Mike ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message aeroelectric-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/AeroElectric-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/aeroelectric-list Browse Digests http://www.matronics.com/digest/aeroelectric-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.