Today's Message Index:
----------------------
0. 12:08 AM - Make Sure You're Listed! List of Contributors Published in December! (Matt Dralle)
1. 12:25 PM - How to wire strobe power supply to switch, power, & gnd (plevyakh)
Message 0
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Make Sure You're Listed! List of Contributors Published |
in December!
Dear Listers,
The List of Contributors (LOC) is just around the corner! In December I post a
list of everyone that so generously made a Contribution to support the Lists.
Its my way of publicly thanking everyone that took a minute to show their appreciation
for the Lists.
Won't you take minute and assure that your name is on the upcoming LOC? Tell others
that you appreciate the Lists. Making a Contribution to support the Lists
is fast and easy using your Visa, MasterCard, or Paypal account:
http://www.matronics.com/contribution
Or, by dropping a personal check in the mail to:
Matronics / Matt Dralle
581 Jeannie Way
Livermore CA 94550
I would like to thank everyone that has so generously made a Contribution thus
far during this year's List Fund Raiser! Remember that its YOUR support that
keeps these Lists running and improving! Don't forget to include a little comment
about how the Lists have helped you!
Thank you!
Matt Dralle
Matronics Email List Administrator
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | How to wire strobe power supply to switch, power, & |
gnd
Folks,
I dug through the archives and couldn't find an answer....so here goes.
I'm wiring a Glastar with composite fuselage. My strobe power supply model "HDACF"
is in the tail cone. My strobe flash units are in the wing tips. The wings
are all aluminum.
The Whelen kit came with 18AWG shielded twisted pair for Pos and Neg hook up of
the power supply.
I need a little help with how to run this shielded twisted pair forward to my switch,
the Power Bus, and ground bus.
What's the correct way to do this? Do I split the wire and just run one up to
the switch and the other up to ground bus, and then run a separate unshielded
wire back to the Power bus from the switch?
I will ground the shield of the 18AWG twisted pair at the strobe power supply box
mounting lug.
Thanks for any guidance,
Howard
--------
Howard Plevyak
GlaStar / North Bend, Ohio
hplevyak@mac.com
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=387926#387926
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|