Today's Message Index:
----------------------
1. 11:30 AM - Connector for shielded wire (bob88)
2. 11:57 AM - Re: Connector for shielded wire (Vern Little)
3. 12:29 PM - Re: Connector for shielded wire (Ken Ryan)
4. 12:56 PM - Re: Connector for shielded wire (bob88)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Connector for shielded wire |
What is best way to connect a shielded wire (shielded part)? Can I use a regular
Molex connector and just treat the shield like one of the other wires? Is there
a better way? I need to connect shielded wiring from my position LED lights
at the wing roots.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=431659#431659
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Connector for shielded wire |
Works just fine, that's what I did in my HR-II and RV-9A.
Vern
-----Original Message-----
From: bob88
Sent: Wednesday, October 08, 2014 11:29 AM
Subject: AeroElectric-List: Connector for shielded wire
What is best way to connect a shielded wire (shielded part)? Can I use a
regular Molex connector and just treat the shield like one of the other
wires? Is there a better way? I need to connect shielded wiring from my
position LED lights at the wing roots.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=431659#431659
Message 3
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Connector for shielded wire |
Is shielding necessary for LED lights? I have two Aveo beacons (Red Baron
XP and Red Baron Mini) and they told me that shielded wire is not necessary.
On Wed, Oct 8, 2014 at 10:29 AM, bob88 <marty.crooks@comcast.net> wrote:
> >
>
> What is best way to connect a shielded wire (shielded part)? Can I use a
> regular Molex connector and just treat the shield like one of the other
> wires? Is there a better way? I need to connect shielded wiring from my
> position LED lights at the wing roots.
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=431659#431659
>
>
Message 4
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Connector for shielded wire |
AeroLED installation instruction for NS90 lights specifies shielded wire...
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=431665#431665
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|