---------------------------------------------------------- AeroElectric-List Digest Archive --- Total Messages Posted Wed 03/16/16: 3 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 08:08 PM - Barker AOA Kit (Justin Jones) 2. 08:26 PM - Re: Barker AOA Kit (Charlie England) 3. 10:51 PM - BNC connectors and SWR (B Tomm) ________________________________ Message 1 _____________________________________ Time: 08:08:26 PM PST US From: Justin Jones Subject: AeroElectric-List: Barker AOA Kit I have heard rumors that the Dave Barker AOA kit is now available again. Has anyone here built one or know where I can get ahold of one? I would love to put one on my plane. Anyone have some experience with one of these kits? Thanks in advance! Justin ________________________________ Message 2 _____________________________________ Time: 08:26:46 PM PST US Subject: Re: AeroElectric-List: Barker AOA Kit From: Charlie England On 3/16/2016 10:06 PM, Justin Jones wrote: > > I have heard rumors that the Dave Barker AOA kit is now available again. Has anyone here built one or know where I can get ahold of one? I would love to put one on my plane. > > Anyone have some experience with one of these kits? > > Thanks in advance! > > Justin http://www.barkeraircraft.com/ ________________________________ Message 3 _____________________________________ Time: 10:51:14 PM PST US From: "B Tomm" Subject: AeroElectric-List: BNC connectors and SWR I am considering moving a VHF Comm antenna to the upper rear fuselage of the RV7, requiring a longer feed cable. To do this, I will make an extension cable which will result in two additional BNC connectors which will result in two BNC's (male and female) be located mid stream in the new antenna feed cable. My questions are... Will these two additional connectors significantly increase the SWR and have a negative affect on the radio's health over time? Will these BNC junctions bundled with other wires "leak" any RF from the BNC joint that will effect other systems? Should I just run a new cable thereby eliminating the junction? Thanks. Bevan ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message aeroelectric-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/AeroElectric-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/aeroelectric-list Browse Digests http://www.matronics.com/digest/aeroelectric-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.