Today's Message Index:
----------------------
1. 12:29 PM - Re: Re: finding the correct crimper (Ken Ryan)
2. 12:34 PM - Re: Re: finding the correct crimper (Robert L. Nuckolls, III)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: finding the correct crimper |
The new crimper worked perfectly, first time. Data on crimper: Purchased
from crimpsupply.com, SKU 37A11001, Metri-Pack/56 Series/Pack-Con Crimping
Tool #6285847. This crimper does not have a slot for the insulation crimp,
but one of my other crimpers does. I probably got a little aggressive with
the insulation crimp, will correct that on futures. The main thing is that
the wire crimp worked perfectly, just as it should, giving a strong, tight
good looking crimp. Pictures attached.
On Sun, May 8, 2016 at 7:13 PM, Robert L. Nuckolls, III <
nuckolls.bob@aeroelectric.com> wrote:
> At 08:53 PM 5/8/2016, you wrote:
>
> Thanks Bob. I have your instruction sheet, so I used it when trying to
> crimp. As I said, I didn't have any trouble with the lighter gauge molex
> terminals. I will have a better quality crimper this week and according to
> the specs it is supposed to work on these exact terminals. As I am running
> low on terminals I will wait for those crimpers. They are very similar to
> the Delphi crimpers in the picture, but this one is definitely supposed to
> be for these exact terminals.
>
>
> I got lots of them. If you run low, drop
> me your mailing address.
>
> Bob . . .
>
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: finding the correct crimper |
At 02:26 PM 5/9/2016, you wrote:
>The new crimper worked perfectly, first time.
>Data on crimper: Purchased from
><http://crimpsupply.com>crimpsupply.com, SKU
>37A11001, Metri-Pack/56 Series/Pack-Con Crimping
>Tool #6285847. This crimper does not have a slot
>for the insulation crimp, but one of my other
>crimpers does. I probably got a little
>aggressive with the insulation crimp, will
>correct that on futures. The main thing is that
>the wire crimp worked perfectly, just as it
>should, giving a strong, tight good looking crimp. Pictures attached.=C2
Good show!
Bob . . .
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|