Today's Message Index:
----------------------
0. 08:07 AM - Value of the List... (Matt Dralle)
1. 10:38 PM - WIRE QUALITY (Mike Pienaar)
Message 0
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Value of the List... |
If you look forward to checking your List email everyday (and a lot of you have
written to say that you do!), then you're probably getting at least $20 or $30
worth of Entertainment from the Lists each year. You'd pay twice that for a
subscription to some magazine or even a dinner out. Isn't the List worth at least
that much to you? Wouldn't it be great if you could pay that amount and get
a well-managed media source free of advertising, SPAM, and viruses? Come to
think of it, you do... :-)
Won't you please take a minute to make your Contribution today and support these
Lists?
http://www.matronics.com/contribution
Or, drop a personal check in the mail to:
Matt Dralle / Matronics
581 Jeannie Way
Livermore CA 94550
USA
I want to say THANK YOU to everyone that has made a Contribution thus far during
this year's List Fund Raiser!! These Lists are made possible exclusively through
YOUR generosity!!
Thank you for your support!
Matt Dralle
Email List Admin.
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Hello,
I have attached a photo of wire that I have put into my project.
The designation is M22759/34-14 90484, printed in green on the white
insulation. Please note the double insulation, a blue sheath under the
white.
I have not noticed this double insulation on any of my other wires.
The problem I have is that the wire seems to be badly tarnished and I am
unable to solder it. I used paste flux on a small piece and the solder still
will not stick.
The sample is from the center on a long piece that has been cut so it is not
as if the end could have corroded.
All my other joints on this wire have been crimp joints and I just did not
notice the bad discoloration on this wire.
My question is will the crimped joints be OK?
Is this wire OK or could it be counterfeit?
Thanks
Mike
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|