---------------------------------------------------------- AeroElectric-List Digest Archive --- Total Messages Posted Wed 11/23/16: 2 ---------------------------------------------------------- Today's Message Index: ---------------------- 0. 08:07 AM - Value of the List... (Matt Dralle) 1. 10:38 PM - WIRE QUALITY (Mike Pienaar) ________________________________ Message 0 _____________________________________ Time: 08:07:39 AM PST US From: Matt Dralle Subject: AeroElectric-List: Value of the List... If you look forward to checking your List email everyday (and a lot of you have written to say that you do!), then you're probably getting at least $20 or $30 worth of Entertainment from the Lists each year. You'd pay twice that for a subscription to some magazine or even a dinner out. Isn't the List worth at least that much to you? Wouldn't it be great if you could pay that amount and get a well-managed media source free of advertising, SPAM, and viruses? Come to think of it, you do... :-) Won't you please take a minute to make your Contribution today and support these Lists? http://www.matronics.com/contribution Or, drop a personal check in the mail to: Matt Dralle / Matronics 581 Jeannie Way Livermore CA 94550 USA I want to say THANK YOU to everyone that has made a Contribution thus far during this year's List Fund Raiser!! These Lists are made possible exclusively through YOUR generosity!! Thank you for your support! Matt Dralle Email List Admin. ________________________________ Message 1 _____________________________________ Time: 10:38:02 PM PST US From: "Mike Pienaar" Subject: AeroElectric-List: WIRE QUALITY Hello, I have attached a photo of wire that I have put into my project. The designation is M22759/34-14 90484, printed in green on the white insulation. Please note the double insulation, a blue sheath under the white. I have not noticed this double insulation on any of my other wires. The problem I have is that the wire seems to be badly tarnished and I am unable to solder it. I used paste flux on a small piece and the solder still will not stick. The sample is from the center on a long piece that has been cut so it is not as if the end could have corroded. All my other joints on this wire have been crimp joints and I just did not notice the bad discoloration on this wire. My question is will the crimped joints be OK? Is this wire OK or could it be counterfeit? Thanks Mike ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message aeroelectric-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/AeroElectric-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/aeroelectric-list Browse Digests http://www.matronics.com/digest/aeroelectric-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.