Today's Message Index:
----------------------
1. 12:44 PM - Re: Garmin magnetometer installation. (Robert L. Nuckolls, III)
2. 02:41 PM - Re: Garmin magnetometer installation. (Stein Bruch)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Garmin magnetometer installation. |
At 10:12 AM 3/17/2017, you wrote:
> Thank you Stein for the reference to the wiring diagram, I
> hadn't seen it, had only looked in the magnetometer section. I
> figured it would require shielded wiring. The twisted pairs I was
> referring to are for the other wiring in the same wing, a Whelen
> LED position/strobe unit and a Facet fuel transfer pump. Whelen
> wants 20 ga wire for their unit and I need 16 gauge wire for the
> pump. I would buy twisted pair wire for these but I only see 22 ga
> twisted pair wire on your website. Maybe the best option is to use
> shielded wire for both.
> Bob, thanks for your offer on shielded wire. I would need 50'
> total for the two runs to the magnetometer.
I've sent you a paypal invoice for shipping
Bob . . .
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Garmin magnetometer installation. |
For the facet pump I wouldn't worry too much if it were me (it's only a
periodic load anyway). For the strobes, we usually see (and stock) 3
conductor x AWG20 or AWG18 depending on what the mfgr spec's.
Cheers,
Stein
From: owner-aeroelectric-list-server@matronics.com
[mailto:owner-aeroelectric-list-server@matronics.com] On Behalf Of Robert L.
Nuckolls, III
Sent: Sunday, March 19, 2017 2:41 PM
Subject: Re: AeroElectric-List: Garmin magnetometer installation.
At 10:12 AM 3/17/2017, you wrote:
Thank you Stein for the reference to the wiring diagram, I hadn't seen
it, had only looked in the magnetometer section. I figured it would require
shielded wiring. The twisted pairs I was referring to are for the other
wiring in the same wing, a Whelen LED position/strobe unit and a Facet fuel
transfer pump. Whelen wants 20 ga wire for their unit and I need 16 gauge
wire for the pump. I would buy twisted pair wire for these but I only see 22
ga twisted pair wire on your website. Maybe the best option is to use
shielded wire for both.
Bob, thanks for your offer on shielded wire. I would need 50' total
for the two runs to the magnetometer.
I've sent you a paypal invoice for shipping
Bob . . .
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|