Today's Message Index:
----------------------
1. 12:20 AM - P-leads (John Keen)
2. 06:30 PM - Re: P-leads (Chuck Birdsall)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Hi Bob,
I have an engine with the Bendix dual magneto. It came without P-leads,
so I=99m wondering whether they are something I can fabricate or
if I will need to purchase them complete?
Best regards,
John.
John Keen
0412 141 833
15 Scott St
Scone NSW Australia 2337
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
John,
You can build your own - but I'm not aware of anyone other than TCM (Continental
owns the Bendix magneto line) that makes the individual parts. To get an idea
what's involved, the Service Manual for your magneto will be here, listed by
model number:
http://www.continentalmotors.aero/support/maintenance-manuals.aspx#ignition
The p-lead parts are called terminal kits in the manual. The how-to should be in
section 9, the parts in section 11. Be sure to watch model number/part numbers
and "usable on" codes to make sure you get the right part numbers.
Aircraft Spruce sells the terminal kits for about US$75 each. The kit consists
of the nut, stepped bushing, insulator, and a washer.
Aside from a bit of soldering they aren't that difficult to assemble. Care must
be taken to keep the overall length of the terminal within the parameters specified.
Too long or too short and you may not get good contact.
OR -
Bogert makes pre-made p-leads for about US$80 each depending on length:
https://bogertaviation.com/collections/p-leads/products/p-leads-d-2000-d-3000-magneto
They're available thru Bogert direct or thru Spruce. Bendix p-leads come in two
varieties (hex nut and round nut) and the round nut variety comes in two different
lengths. Watch the video at the bottom of the Bogert web site. Make sure
the version you order matches the model number of your magneto.
Regards,
Chuck
---- John Keen <john@johnkeen.com.au> wrote:
> Hi Bob,
>
> I have an engine with the Bendix dual magneto. It came without P-leads, so Im
wondering whether they are something I can fabricate or if I will need to purchase
them complete?
>
> Best regards,
> John.
>
> John Keen
> 0412 141 833
> 15 Scott St
> Scone NSW Australia 2337
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|