Today's Message Index:
----------------------
1. 12:56 PM - SOLID STATE RELAY (user9253)
2. 01:26 PM - Re: SOLID STATE RELAY (user9253)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | SOLID STATE RELAY |
My RV-12 has removable wings. There are limit switches on the 2 pins that lock
the wings in place.
Originally the limit switches were wired to a form C relay. If the relay was energized,
the start circuit was enabled.
If the relay was not energized, the start circuit was disabled and the normally
closed relay contacts turned on a LED warning light.
Not satisfied with leaving well enough alone, I replaced the relay with MOSFET
transistors. Below is a picture of the circuit.
--------
Joe Gores
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=481643#481643
Attachments:
http://forums.matronics.com//files/solid_state_relay_210.jpg
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: SOLID STATE RELAY |
After posting the schematic, I realized that the 2K2 resistor on the right side
is not needed.
--------
Joe Gores
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=481644#481644
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|