Today's Message Index:
----------------------
1. 11:02 AM - Tachometer Mitchell Rotax 912 (DANIEL PELLETIER)
2. 12:23 PM - Re: Tachometer Mitchell Rotax 912 (user9253)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Tachometer Mitchell Rotax 912 |
Anyone can tell me how to wire my tachometer Mitchell D1-112-5240. There is 3 pins
on the backplate G for the ground and a + and -. From my Rotax 912 uls, I
understand that I must use the blue/yellow and the white/yellow as it appears
on that instructions.
https://www.manualslib.com/manual/847567/Rotax-912-Series.html?page=118#manual
Which oen is the (+) and which one is the (-)?
Daniel Pelletier
Envoy de mon iPad
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Tachometer Mitchell Rotax 912 |
The Blu/Yel and Wht/Yel wires are correct for the tach coil. But they are AC,
not DC. The Mitchell website lists the D1-112-5240 as Special-Rotax 914. That
infers that it is made for an AC tach signal. But it is best to call the manufacturer
to verify.
--------
Joe Gores
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=488992#488992
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|