Today's Message Index:
----------------------
1. 05:31 AM - Re: DC Wiring Diagrams for SPA Panther LS (jameshansen55)
2. 05:57 AM - Re: Thermocouple Accuracy (dj_theis)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: DC Wiring Diagrams for SPA Panther LS |
There can be a number of reasons behind the slow speed of your internet. But to make sure of the actual reason, you have to perform a speed test. For this purpose, you can use this site that weve created by keeping in view what a user needs https://www.speedput.com/. Theres nothing like a long and tough process to start the speed test. The results will be displayed on your screen in just a few seconds. After having the results you can easily determine the actual reason thats causing your internet to slow down.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=501313#501313
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Thermocouple Accuracy |
I like Charlies suggestion of checking other calibration configurations on the
MGL.
To respond to Mikes first question, is 10 degrees close enough?
It probably depends on your expectations and willingness to accommodate a known
error in your Temperatures. Knowing the source of the error and insuring it
remains constant is probably as important.
Personally, I would not accept it as good enough.
A second method of measurement is often useful. I purchased a very low cost unit
to compare to my trusted Fluke.
The attached photo shows a 1 degree difference in one photo but it is due to elevating
the TC bulb at different heights from the floor.
I swapped the 4 TC probes I had between the two meters in various combinations
and could not see any difference in response or value reported between the Fluke
and the low cost alternative. Two of the probes came with the meter and two
were from Omegs.
My conclusion on first sampling of the low cost TC meter is that it is quite adequate.
No telling how well it will perform a year from now, for sure. Only
time will tell.
Dan Theis
https://www.amazon.com/dp/B071V7T6TZ?psc=1&smid=A1L1WUWYKZGTBQ&ref_=chk_typ_imgToDp
--------
Scratch building Sonex #1362
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=501316#501316
Attachments:
http://forums.matronics.com//files/6f96d740_75f6_421b_ab09_dd787a0c95ef_117.jpeg
http://forums.matronics.com//files/37d32604_3c43_4a30_b297_7108a03f07af_117.jpeg
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|