Today's Message Index:
----------------------
1. 07:20 PM - Re: AMP Connector (?) Help Needed (Steve Kelly)
2. 08:20 PM - Re: AMP Connector (?) Help Needed (David Saylor)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: AMP Connector (?) Help Needed |
What kind of high voltage connectors are you referring to?
Steve
On Fri, Jul 23, 2021 at 8:26 PM David Saylor <saylor.dave@gmail.com> wrote:
> One quick caution about connectorizing the (old fashioned flash tube)
> strobes: make sure your connector is rated for the very high voltage. I
> learned the hard way :-(
>
> --Dave
>
>>
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: AMP Connector (?) Help Needed |
The Molex connectors that Whelen has used forever are obviously up to the
task, but I tried running the wiring from the strobe power supply to the
flash tubes via an Amp CPC-type connector. I'm not sure if the pins or the
housing were the weak point, but the connector melted.
If you're installing LED strobes please disregard.
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|