Today's Message Index:
----------------------
1. 08:19 AM - Re: Rotax 912 ULS schematics (DANIEL PELLETIER)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Rotax 912 ULS schematics |
I=99m trying to solve that problem too.
I use diff=C3=A9rents sources, but I think the best one is figure Z-11 of bo
b Nuckolls book. You can also read the note 3 of page Z-7 r=C3=A9vision 12. A
nd at least the following diagram
http://www.steinair.com/wp-content/uploads/2016/05/2-50-Typical-use-PMAG-POW
ER-TEST-drawing.pdf
But it=99s not exactly the same switch, in the Steinair diagram it
=99s a S700-2-50 (on-on-(on), Bob suggest the S700-2-5 on-off-(on). The =C2=AB
off =C2=BB position cut the ground to the ignition which allows the operati
on. When you close the switch =C2=AB on =C2=BB position, you ground the igni
tion and the operation end. The momentary =C2=AB on =C2=BB position activate
the starter solenoid.
Hope it will be useful.
Daniel Pelletier
Envoy=C3=A9 de mon iPad
> Le 10 ao=C3=BBt 2021 =C3- 12:21, Neal George <neal.george@gmail.com> a =C3
=A9crit :
@gmail.com>
>
> Gentlemen -
> Searching for schematics for the Rotax 912 ULS reveals a few block diagram
s, but nothing with any detail. Even the maintenance and installation manua
ls are thin on specifics.
>
> Specifically, I need the pin-out for the two 6-pin connector blocks for th
e Ignition modules...
>
>
> Neal George
>
>
>
>
>
==========================
=========
==========================
=========
==========================
=========
==========================
=========
==========================
=========
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|