Today's Message Index:
----------------------
1. 01:22 PM - Re: Engine Mount Alignment (TIM MOSES)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Engine Mount Alignment |
Does any one have an electrical schmatic for the Allegro flap system?
My flaps will go down but will not go back up.
----- Original Message -----
From: TIM MOSES
To: allegro-list@matronics.com
Sent: Monday, October 01, 2007 6:35 PM
Subject: Allegro-List: Engine Mount Alignment
Has any one had a problem getting the engine mount level relative to
the leveled fuselage (per the assembly instructions)? I currently have
about 3.5 degrees of down thrust. If I shorten the upper mount
supports, I am bending the lower engine rubber mounts quite a bit.
Could the mount be bent from a hard landing? I did not build this
plane.
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|