Today's Message Index:
----------------------
1. 07:37 AM - Stall Warning Failure (ledson)
2. 07:45 AM - Re: Stall Warning Failure (Brad Kramer)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Stall Warning Failure |
I'm trying to find out if anyone else is have this problem with the Stall Warning
system on their Allegro 2000.
Last Saturday during cruise flight, the stall warning horn started sounding. I
was at approximately 95 mph. The stall warning light did not come on and there
was not any changes in the AOA. Upon landing, the stall warning horn stopped
sounding and the stall warning light came on like it normally does when landing.
I checked the feed tube to ensure that there wasn't anything blocking it
and then tried several more takeoff and landings with the same results. I'm
assuming that it is either a failure of the stall warning control board or the
ASI. Right now I'm at a loss on how to proceed. I don't have a wiring schematic
of the stall warning system and without one I'm not sure what's next. So
if anyone has any experience with this system I would certainly appreciate your
advise.
Thanks,
Larry Edson
N4362C
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=379587#379587
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Stall Warning Failure |
I wouldnt think the ASI is involved unless we have a really unusual system. Maybe
whatever control board it has or a wiring short to the horn?
Brad N221FA. Bismarck ND
P.s. was good to see the allegro folks with a display at OSH
Brad Kramer / VisionTech
(701) 222-3009
ledson <ledson@oneil.com> wrote:
I'm trying to find out if anyone else is have this problem with the Stall Warning
system on their Allegro 2000.
Last Saturday during cruise flight, the stall warning horn started sounding. I
was at approximately 95 mph. The stall warning light did not come on and there
was not any changes in the AOA. Upon landing, the stall warning horn stopped
sounding and the stall warning light came on like it normally does when landing.
I checked the feed tube to ensure that there wasn't anything blocking it and
then tried several more takeoff and landings with the same results. I'm assuming
that it is either a failure of the stall warning control board or the ASI.
Right now I'm at a loss on how to proceed. I don't have a wiring schematic of
the stall warning system and without one I'm not sure what's next. So if anyone
has any experience with this system I would certainly appreciate your advise.
Thanks,
Larry Edson
N4362C
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=379587#379587
_____________________________________________
_____________________________________________
_____________________________________________
_____________________________________________
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|