Today's Message Index:
----------------------
1. 03:23 PM - Re: Stall Warning Failure (ledson)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Stall Warning Failure |
Brad,
>From what I can gather, the ASI activates the stall warning system at around 30
mph plus it activates stall warning light at about 5 mph above stall. The pressure
switch activates the stall warning horn when the pressure that it senses
drops below the setting.
I'm still trying to get a wiring schematic for the control board. I do have the
wiring diagram that shows how the system is wired, but without understanding
the logic that is on the board I'm at a loss. I've tried everything that has
been suggested with no change. I would like to know the measured pressure that
activates the pressure switch. That would allow me to adjust the pressure
prior to flight without the trial and error method that has been suggested.
If anyone out there has any suggestions, I'm certainly open to them.
Thanks,
Larry
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=381279#381279
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|