Today's Message Index:
----------------------
1. 06:57 PM - Supporting the other ends of our gyros (Ralph E. Capen)
Message 1
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Supporting the other ends of our gyros |
--> Avionics-List message posted by: "Ralph E. Capen" <recapen@earthlink.net>
Fellow listers,
What are you doing (have you done) to support the forward (back) ends of your long
gyros?
A couple of mine will go through the next forward bulkhead so I can probably rivet
on a piece of angle and clamp the gyro to that. One (AI) is too short but
is right on top of another (HSI) that goes through the next forward bulkhead
- I was thinking of making up a spacer to put those two together and clamp them
together using the support on the one that goes all the way through to hold
both. Another of mine (S-Tec30 TC/AP) is also too short and is not close enough
to another one to "lean" on.
Your thoughts please,
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|