Today's Message Index:
----------------------
1. 07:35 PM - Flush Mount Template for GPSMAP 196 (N27160@aol.com)
2. 11:23 PM - Re: Flush Mount Template for GPSMAP 196 (Werner Schneider)
3. 11:46 PM - Re: Flush Mount Template for GPS (Gerry Holland)
Message 1
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Flush Mount Template for GPSMAP 196 |
at.a.big.ISP@matronics.com
--> Avionics-List message posted by: N27160@aol.com
Does anyone have a template to cut a panel in order to flush mount a Garmin
GPSMap 196?
Or, does anyone ready make a panel for a std 6.25" wide radio stack with the
the cutout for the 196?
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Flush Mount Template for GPSMAP 196 |
--> Avionics-List message posted by: "Werner Schneider" <wernerschneider@compuserve.com>
Hello ??
I did flushmount mine in a 6.25" stack, I have no template, as it was a
trial and error (or try and sand approach), I did use the dash mount for it
and it works quite well. I can send you some pictures if you like.
Werner
----- Original Message -----
From: <N27160@aol.com>
<avionics-list@matronics.com.ADDR_NUMS_AT_BIGSITE.Uses.an.address.with.lots.
of.numbers>; <at.a.big.ISP@matronics.com>
Subject: Avionics-List: Flush Mount Template for GPSMAP 196
> --> Avionics-List message posted by: N27160@aol.com
>
> Does anyone have a template to cut a panel in order to flush mount a
Garmin
> GPSMap 196?
>
> Or, does anyone ready make a panel for a std 6.25" wide radio stack with
the
> the cutout for the 196?
>
>
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Flush Mount Template for GPS |
--> Avionics-List message posted by: Gerry Holland <gnholland@onetel.com>
Hi!
> I did flushmount mine in a 6.25" stack, I have no template, as it was a
> trial and error , I did use the dash mount for it and it works quite well.
As in Werner's answer above I too have done this.
Make the 6.25" Plate to fit first and then use a paper template to get a
rough silhouette of the GPS and positioning. Mine was a GPS III Pilot. Using
the 'cradle' it often gets supplied with simplifies the attachment to the
Face plate.
I have photos too if reqd. gnholland@onetel.com
Regards
Gerry
Gerry Holland
Europa 384
G-FIZY
+44 7808 402404
gnholland@onetel.com
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|