----------------------------------------------------------
                           Avionics-List Digest Archive
                                      ---
                     Total Messages Posted Mon 11/03/03: 3
           ----------------------------------------------------------
 
 
Today's Message Index:
----------------------
 
     1. 07:35 PM - Flush Mount Template for GPSMAP 196  (N27160@aol.com)
     2. 11:23 PM - Re: Flush Mount Template for GPSMAP 196  (Werner Schneider)
     3. 11:46 PM - Re: Flush Mount Template for GPS  (Gerry Holland)
 
 
 
________________________________  Message 1  _____________________________________


Time: 07:35:58 PM PST US
From: N27160@aol.com
Subject: Avionics-List: Flush Mount Template for GPSMAP 196
   at.a.big.ISP@matronics.com

--> Avionics-List message posted by: N27160@aol.com

Does anyone have a template to cut a panel in order to flush mount a Garmin 
GPSMap 196?

Or, does anyone ready make a panel for a std 6.25" wide radio stack with the 
the cutout for the 196?






________________________________  Message 2  _____________________________________


Time: 11:23:48 PM PST US
From: "Werner Schneider" <wernerschneider@compuserve.com>
Subject: Re: Avionics-List: Flush Mount Template for GPSMAP 196

--> Avionics-List message posted by: "Werner Schneider" <wernerschneider@compuserve.com>

Hello ??

I did flushmount mine in a 6.25" stack, I have no template, as it was a
trial and error (or try and sand approach), I did use the dash mount for it
and it works quite well. I can send you some pictures if you like.

Werner

----- Original Message -----
From: <N27160@aol.com>
<avionics-list@matronics.com.ADDR_NUMS_AT_BIGSITE.Uses.an.address.with.lots.
of.numbers>; <at.a.big.ISP@matronics.com>
Subject: Avionics-List: Flush Mount Template for GPSMAP 196


> --> Avionics-List message posted by: N27160@aol.com
>
> Does anyone have a template to cut a panel in order to flush mount a
Garmin
> GPSMap 196?
>
> Or, does anyone ready make a panel for a std 6.25" wide radio stack with
the
> the cutout for the 196?
>
>






________________________________  Message 3  _____________________________________


Time: 11:46:21 PM PST US
Subject: Re: Avionics-List: Flush Mount Template for GPS
From: Gerry Holland <gnholland@onetel.com>

--> Avionics-List message posted by: Gerry Holland <gnholland@onetel.com>

Hi!

> I did flushmount mine in a 6.25" stack, I have no template, as it was a
> trial and error , I did use the dash mount for it and it works quite well.

As in Werner's answer above I too have done this.

Make the 6.25" Plate to fit first and then use a paper template to get a
rough silhouette of the GPS and positioning. Mine was a GPS III Pilot. Using
the 'cradle' it often gets supplied with simplifies the attachment to the
Face plate.

I have photos too if reqd. gnholland@onetel.com

Regards

Gerry

Gerry Holland
Europa 384
G-FIZY
+44 7808 402404
gnholland@onetel.com