---------------------------------------------------------- Avionics-List Digest Archive --- Total Messages Posted Thu 07/29/04: 2 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 11:11 AM - KMD 150 (Bob Gibfried) 2. 11:47 AM - Re: KMD 150 (John Schroeder) ________________________________ Message 1 _____________________________________ Time: 11:11:51 AM PST US From: "Bob Gibfried" Subject: Avionics-List: KMD 150 --> Avionics-List message posted by: "Bob Gibfried" Not an avionics expert Other than power, ground and antenna connection for the Bendix King KMD 150 MFD with GPS, is there any other circuit requirements? I'm ordering a KA 92 antenna but A/S wouldn't provide a pig tail. Course I only talked to the girl on the order desk. Would be helpful if anyone could provide the pin numbers for the connections. Thanks Bob, Wichita ________________________________ Message 2 _____________________________________ Time: 11:47:00 AM PST US Subject: Re: Avionics-List: KMD 150 From: "John Schroeder" --> Avionics-List message posted by: "John Schroeder" Bob - You should be able to download the installation manual for that KMD 150. If so, there is usually a pinout for the cabling needed to make it go. I would suspect that there are a few other in or out connections for the box. Dimming may be one of them and GPS output for other instrumentation may be another. If you have other navaid/comm boxes, you might consider using the Approach Systems buss to connect them as necessary. They supply all of the interconnect cabling between the boxes and thei buss. They have a VFR and a full IFR version. http://www.approach-systems.com/index.html Hope this helps, John > Not an avionics expert Other than power, ground and antenna connection > for > the Bendix King KMD 150 MFD with GPS, is there any other circuit > requirements? > > I'm ordering a KA 92 antenna but A/S wouldn't provide a pig tail. > Course I > only talked to the girl on the order desk.