Avionics-List Digest Archive

Thu 12/29/05


Total Messages Posted: 6



Today's Message Index:
----------------------
 
     1. 09:55 AM - Re: KLN-89B Question ()
     2. 11:14 AM - Re: KLN-89B Question (John Rippengal)
     3. 11:46 AM - Re: KLN-89B Question ()
     4. 01:12 PM - Garmin 340 Stereo Input Pinout. (JAC)
     5. 02:37 PM - RES: Garmin 340 Stereo Input Pinout. (Roberto Honorato)
     6. 06:16 PM - Re: RES: Garmin 340 Stereo Input Pinout. (Tim Olson)
 
 
 


Message 1


  • INDEX
  • Back to Main INDEX
  • NEXT
  • Skip to NEXT Message
  • LIST
  • Reply to LIST Regarding this Message
  • SENDER
  • Reply to SENDER Regarding this Message
    Time: 09:55:13 AM PST US
    Subject: KLN-89B Question
    From: <George.Kuehn@dot.gov>
    --> Avionics-List message posted by: <George.Kuehn@dot.gov> Thanks John, I seem to have good connections so far with no problem getting everything to seat fully. The particular install test that failed is limited to the antenna input. Since unit checked ok at the shop and I'm getting voltage at the antenna end of the RG400 lead, I must assume that it's the KA-92. But before I layout big bucks for a new antenna, I was hoping to able to test this one myself. It looks like another trip to the avionics shop is in order to test the antenna. George -----Original Message----- From: owner-avionics-list-server@matronics.com [mailto:owner-avionics-list-server@matronics.com] On Behalf Of John Rippengal Subject: Re: Avionics-List: KLN-89B Question --> Avionics-List message posted by: "John Rippengal" <j.rippengal@cytanet.com.cy> George, I had a lot of trouble when trying to install a KLN89B. The problem turned out to be the rather short reach that the computer type pins have in their connectors. I was used to the older type of avionics with the long flat contacts. I found that it was easy for a very small piece of debris or a slight misalignment of the panel to prevent the unit going fully home and ensuring all the pins made contact. Hope it is something as stupidly simple in your case! John From: <George.Kuehn@dot.gov> > --> Avionics-List message posted by: <George.Kuehn@dot.gov> > > Hi Bill, > > There is a small green plastic module with a stab connector mounted in > the back plate on the lower left side. I believe this is the > configuration module if I recall correctly form the install manual. Now > whether it is working properly is another matter. > > Thanks, > George


    Message 2


  • INDEX
  • Back to Main INDEX
  • PREVIOUS
  • Skip to PREVIOUS Message
  • NEXT
  • Skip to NEXT Message
  • LIST
  • Reply to LIST Regarding this Message
  • SENDER
  • Reply to SENDER Regarding this Message
    Time: 11:14:51 AM PST US
    From: "John Rippengal" <j.rippengal@cytanet.com.cy>
    Subject: Re: KLN-89B Question
    --> Avionics-List message posted by: "John Rippengal" <j.rippengal@cytanet.com.cy> Looks as though you are right George. Pity about the cheap antenna escalating in price because of certification. John From: <George.Kuehn@dot.gov> > > Thanks John, > > I seem to have good connections so far with no problem getting > everything to seat fully. The particular install test that failed is > limited to the antenna input. Since unit checked ok at the shop and I'm > getting voltage at the antenna end of the RG400 lead, I must assume that > it's the KA-92. But before I layout big bucks for a new antenna, I was > hoping to able to test this one myself. It looks like another trip to > the avionics shop is in order to test the antenna. > > George


    Message 3


  • INDEX
  • Back to Main INDEX
  • PREVIOUS
  • Skip to PREVIOUS Message
  • NEXT
  • Skip to NEXT Message
  • LIST
  • Reply to LIST Regarding this Message
  • SENDER
  • Reply to SENDER Regarding this Message
    Time: 11:46:28 AM PST US
    Subject: KLN-89B Question
    From: <George.Kuehn@dot.gov>
    --> Avionics-List message posted by: <George.Kuehn@dot.gov> Sometimes you get lucky. But in most cases (like this one) the most you can expect, is to get is what you pay for. George -----Original Message----- From: owner-avionics-list-server@matronics.com [mailto:owner-avionics-list-server@matronics.com] On Behalf Of John Rippengal Subject: Re: Avionics-List: KLN-89B Question --> Avionics-List message posted by: "John Rippengal" <j.rippengal@cytanet.com.cy> Looks as though you are right George. Pity about the cheap antenna escalating in price because of certification. John From: <George.Kuehn@dot.gov> > > Thanks John, > > I seem to have good connections so far with no problem getting > everything to seat fully. The particular install test that failed is > limited to the antenna input. Since unit checked ok at the shop and I'm > getting voltage at the antenna end of the RG400 lead, I must assume that > it's the KA-92. But before I layout big bucks for a new antenna, I was > hoping to able to test this one myself. It looks like another trip to > the avionics shop is in order to test the antenna. > > George


    Message 4


  • INDEX
  • Back to Main INDEX
  • PREVIOUS
  • Skip to PREVIOUS Message
  • NEXT
  • Skip to NEXT Message
  • LIST
  • Reply to LIST Regarding this Message
  • SENDER
  • Reply to SENDER Regarding this Message
    Time: 01:12:45 PM PST US
    From: "JAC" <Joetul@cox.net>
    Subject: Garmin 340 Stereo Input Pinout.
    --> Avionics-List message posted by: "JAC" <Joetul@cox.net> Avionics shop installed a Garmin 340 audio panel several years ago but left off the stereo input. Is there a simple solution to DIY the stereo input?


    Message 5


  • INDEX
  • Back to Main INDEX
  • PREVIOUS
  • Skip to PREVIOUS Message
  • NEXT
  • Skip to NEXT Message
  • LIST
  • Reply to LIST Regarding this Message
  • SENDER
  • Reply to SENDER Regarding this Message
    Time: 02:37:02 PM PST US
    From: "Roberto Honorato" <roberto.honorato@williamaeronautica.com.br>
    Subject: Garmin 340 Stereo Input Pinout.
    --> Avionics-List message posted by: "Roberto Honorato" <roberto.honorato@williamaeronautica.com.br> Hello, You need to pass one more wire to each phone jack. You also have to install a mono/stereo switch in the panel, because if you connect a monophone the stereo will be lost in all the phones. The best option is to use shielded cable. I can send you the wiring, let me know in pvt if you want. Have a good one Roberto -----Mensagem original----- De: owner-avionics-list-server@matronics.com [mailto:owner-avionics-list-server@matronics.com] Em nome de JAC Enviada em: quinta-feira, 29 de dezembro de 2005 19:12 Para: avionics-list@matronics.com Assunto: Avionics-List: Garmin 340 Stereo Input Pinout. --> Avionics-List message posted by: "JAC" <Joetul@cox.net> Avionics shop installed a Garmin 340 audio panel several years ago but left off the stereo input. Is there a simple solution to DIY the stereo input? -- --


    Message 6


  • INDEX
  • Back to Main INDEX
  • PREVIOUS
  • Skip to PREVIOUS Message
  • NEXT
  • Skip to NEXT Message
  • LIST
  • Reply to LIST Regarding this Message
  • SENDER
  • Reply to SENDER Regarding this Message
    Time: 06:16:33 PM PST US
    From: Tim Olson <Tim@MyRV10.com>
    Subject: Re: Garmin 340 Stereo Input Pinout.
    --> Avionics-List message posted by: Tim Olson <Tim@MyRV10.com> I think he means stereo input jack for music. That should be really easy. If you go to PS Engineering and look at the PS8000, you can download the wiring instructions for that. They're the same as the Garmin and are interchangeable. You should just have to wire the jack. 3 conductor shielded and you'll be all set. Tim Olson -- RV-10 DO NOT ARCHIVE Roberto Honorato wrote: > --> Avionics-List message posted by: "Roberto Honorato" <roberto.honorato@williamaeronautica.com.br> > > Hello, > > You need to pass one more wire to each phone jack. > You also have to install a mono/stereo switch in the panel, because if you > connect a monophone the stereo will be lost in all the phones. > The best option is to use shielded cable. > > I can send you the wiring, let me know in pvt if you want. > > Have a good one > > Roberto > > > -----Mensagem original----- > De: owner-avionics-list-server@matronics.com > [mailto:owner-avionics-list-server@matronics.com] Em nome de JAC > Enviada em: quinta-feira, 29 de dezembro de 2005 19:12 > Para: avionics-list@matronics.com > Assunto: Avionics-List: Garmin 340 Stereo Input Pinout. > > --> Avionics-List message posted by: "JAC" <Joetul@cox.net> > > Avionics shop installed a Garmin 340 audio panel several years ago but > left off the stereo input. Is there a simple solution to DIY the stereo > input? > > > > > > > > > > > > > > >




    Other Matronics Email List Services

  • Post A New Message
  •   avionics-list@matronics.com
  • UN/SUBSCRIBE
  •   http://www.matronics.com/subscription
  • List FAQ
  •   http://www.matronics.com/FAQ/Avionics-List.htm
  • Full Archive Search Engine
  •   http://www.matronics.com/search
  • 7-Day List Browse
  •   http://www.matronics.com/browse/avionics-list
  • Browse Avionics-List Digests
  •   http://www.matronics.com/digest/avionics-list
  • Browse Other Lists
  •   http://www.matronics.com/browse
  • Live Online Chat!
  •   http://www.matronics.com/chat
  • Archive Downloading
  •   http://www.matronics.com/archives
  • Photo Share
  •   http://www.matronics.com/photoshare
  • Other Email Lists
  •   http://www.matronics.com/emaillists
  • Contributions
  •   http://www.matronics.com/contributions

    These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.

    -- Please support this service by making your Contribution today! --