Today's Message Index:
----------------------
1. 12:39 PM - Connector (Bob Gibfried)
2. 02:14 PM - Re: Connector (Gerry Holland)
3. 02:48 PM - Re: Connector (Mike Ferrer)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Can anyone suggest a source for a female 37 pin connector for a KMD 150 o
n
the inter net?
After three weeks of promises, my avionics shop is too busy to make a
pigtail with just power and ground. The on line sites I've loojked at, i
t's
difficult to dertermine the correct connector. Would probably also need
a
crimper.
Thanks
Bob, Wichita
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
> Bob Hi!
>
> Can anyone suggest a source for a female 37 pin connector for a KMD 150 o
n the
> inter net?
>
> Try: http://www.northerntech.com/ntc_dc.htm
>
> I have a KMD150 and these look familiar. As I remember when wiring I didn
=B9t
> use a Crimp Tool as difficult to find and I carefully solder the very few
> connections I needed to make.
>
> Regards
>
> Gerry
> Europa XS Trigear
> G-FIZY
>
Message 3
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Bob,
You can buy the connector from www.mouser.com. It's a DSub connector
and you can get them in either solder or crimp style. Or, if you
prefer, I have the crimp style connector in stock and can add the
power/ground pigtails tonight and send it out tomorrow. Send me an email
at mike@ferrer-aviation.com if I can help.
Mike
----- Original Message -----
From: Bob Gibfried
To: avionics-list@matronics.com
Sent: Wednesday, August 23, 2006 2:38 PM
Subject: Avionics-List: Connector
Can anyone suggest a source for a female 37 pin connector for a
KMD 150 on the inter net?
After three weeks of promises, my avionics shop is too busy to
make a pigtail with just power and ground. The on line sites I've
loojked at, it's difficult to dertermine the correct connector. Would
probably also need a crimper.
Thanks
Bob, Wichita
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|