Today's Message Index:
----------------------
1. 05:02 AM - Transponder King KX76a (Mike Hoffman)
2. 07:12 AM - Re: Transponder King KX76a (Charles Reiche)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Transponder King KX76a |
I have a separate wire (pin 2) for my transponder dimmer light. I do not want to
hook it up to a dimmer but would like it to light up when I turn the unit on.
I do not have a pin out for my transponder and wounder if someone could tell
me how to correct this problem.
Thanks
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=150008#150008
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Transponder King KX76a |
If you hook it up to your power source (bus, with a 1A fuse holder just to
protect it) make sure that the kt76 is wired for 14v lighting. I know that
these units run off 14V and work through a dropping resistor when I install
them in 28v airplanes, but I beleive that the lighting circuit can run on
either depending where you put grounds. Or you could configure it for 28V
lights and it would them be half bright all the time. Im not sure. Maybe
some fiddling with a multi-pole switch that could be configured to brighten
or dim the backlighting inside the unit. Having it light up when you turn
on the unit cant really be done(if you mean the OFF/STBY/ON/ALT
switch)...... well just have the lighting power come after the avionics
master or whatever.... just some ideas.
Charles
----- Original Message -----
From: "Mike Hoffman" <mhoffman9@tampabay.rr.com>
Sent: Sunday, December 02, 2007 8:01 AM
Subject: Avionics-List: Transponder King KX76a
> <mhoffman9@tampabay.rr.com>
>
> I have a separate wire (pin 2) for my transponder dimmer light. I do not
> want to hook it up to a dimmer but would like it to light up when I turn
> the unit on. I do not have a pin out for my transponder and wounder if
> someone could tell me how to correct this problem.
>
> Thanks
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=150008#150008
>
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|