Today's Message Index:
----------------------
1. 09:30 AM - Re: KLX 135A GPS BOARD (David LLoyd)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: KLX 135A GPS BOARD |
If you have the board out to where you can examine it.....some suggestions.
Maybe the problem is a cold-like solder joint that opens under heat/cold or
vibration. Use one of those desk top magnifier stand gadgets and a good
light and look at all the connections as close as possible. Flex the board
a bit; not too much. You may visually be able to see a hairline break in a
component connection, signal etch track, or connector attachment point.
Also, look at any pin/connector that look different from adjacent pins, etc.
You could have a cold - hot problem where a pin looses signal path from a
mis-aligned or distorted pin.
This has worked for me several times in the past. It takes patience. Or,
hopefully, someone on the List will send you a 135A to make the swap out
easy. Sorry, ....I do not have a 135.
David
____________________________________________________
----- Original Message -----
From: "Krawietz" <krawietz@gvtc.com>
Sent: Monday, July 05, 2010 8:50 AM
Subject: Avionics-List: KLX 135A GPS BOARD
>
> I have a KLX 135A that has an intermittent GPS Board. The Factory says it
> is the older generation and is not repairable. Anyone parting out one
> that is willing to sell me this board? Any thoughts on a replacement.
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=303803#303803
>
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|