Today's Message Index:
----------------------
1. 07:26 AM - Re: Another one bites the dust (Tommy Mathieu)
2. 07:32 AM - Re: Another one bites the dust (Robert Feldtman)
3. 09:38 AM - Volt/Amp meter (Tom Fisher)
4. 10:49 AM - Re: Volt/Amp meter (mike floyd)
5. 10:53 AM - 500S Pilot Door Placard (KenWHyde@aol.com)
6. 10:56 AM - Re: Volt/Amp meter (Tom Fisher)
7. 12:57 PM - Re: Another one bites the dust (Gary Moshluk)
8. 02:10 PM - Re: 500S Pilot Door Placard (lloyd SILVERMAN)
9. 06:40 PM - TCFG FLY-IN (yourtcfg@aol.com)
10. 07:31 PM - Re: Fly-in (John Vormbaum)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Another one bites the dust |
Gentlemen:
I am having a problem with a right main gear landing light. It has
become
intermittent and the gear must be put down more than once to get the
light
to stay illuminated. Any thoughts on what might be causing this to
occur.
Our local shop looked at this but has not been able to run down the
problem.
As always, I greatly appreciate any advice ya'll can provide on the
subject.
I am learning as I go along.
Sincerely,
Tommy Mathieu
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Another one bites the dust |
dirty micro switch till proven otherwise - are your bungee cords fresh?
bobf
On Tue, Aug 12, 2008 at 9:26 AM, Tommy Mathieu <tmathieu@msn.com> wrote:
> Gentlemen:
>
> I am having a problem with a right main gear landing light. It has become
> intermittent and the gear must be put down more than once to get the light
> to stay illuminated. Any thoughts on what might be causing this to occur.
> Our local shop looked at this but has not been able to run down the problem.
> As always, I greatly appreciate any advice ya'll can provide on the subject.
> I am learning as I go along.
>
> Sincerely,
>
> Tommy Mathieu
>
Message 3
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
I have a new snag, when I push the Volt/Amp button the needle goes left
instead of displaying the Volts.
Both Alternators are still putting out Voltage so it might be just the
gauge.
Any opinions?
Tom
C-GISS
680FLP (Mr.RPM)
----- Original Message -----
From: Robert Feldtman
To: commander-list@matronics.com
Sent: Tuesday, August 12, 2008 7:30 AM
Subject: Re: Commander-List: Another one bites the dust
dirty micro switch till proven otherwise - are your bungee cords
fresh?
bobf
On Tue, Aug 12, 2008 at 9:26 AM, Tommy Mathieu <tmathieu@msn.com>
wrote:
Gentlemen:
I am having a problem with a right main gear landing light. It has
become intermittent and the gear must be put down more than once to get
the light to stay illuminated. Any thoughts on what might be causing
this to occur. Our local shop looked at this but has not been able to
run down the problem. As always, I greatly appreciate any advice ya'll
can provide on the subject. I am learning as I go along.
Sincerely,
Tommy Mathieu
Message 4
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Voltmeter fuse in the fuse block mounted in the master power panel has a lo
ose clip that holds the fuse in place.
From: tfisher@commandergroup.bc.caTo: commander-list@matronics.comSubject:
Commander-List: Volt/Amp meterDate: Tue=2C 12 Aug 2008 09:38:31 -0700
I have a new snag=2C when I push the Volt/Amp button the needle goes left i
nstead of displaying the Volts.
Both Alternators are still putting out Voltage so it might be just the gaug
e.
Any opinions?
Tom
C-GISS
680FLP (Mr.RPM)
----- Original Message -----
From: Robert Feldtman
Sent: Tuesday=2C August 12=2C 2008 7:30 AM
Subject: Re: Commander-List: Another one bites the dust
dirty micro switch till proven otherwise - are your bungee cords fresh?bobf
On Tue=2C Aug 12=2C 2008 at 9:26 AM=2C Tommy Mathieu <tmathieu@msn.com> wro
te:
Gentlemen:
I am having a problem with a right main gear landing light. It has become i
ntermittent and the gear must be put down more than once to get the light t
o stay illuminated. Any thoughts on what might be causing this to occur. Ou
r local shop looked at this but has not been able to run down the problem.
As always=2C I greatly appreciate any advice ya'll can provide on the subje
ct. I am learning as I go along.
Sincerely=2C
Tommy Mathieu
href="http://www.matronics.com/Navigator?Commander-List">http://www.matro
nics.com/Navigator?Commander-List
href="http://forums.matronics.com">http://forums.matronics.com
href="http://www.matronics.com/contribution">http://www.matronics.com/c
_________________________________________________________________
Your PC=2C mobile phone=2C and online services work together like never bef
ore.
Message 5
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | 500S Pilot Door Placard |
Gentlemen!
Anyone know where I can find the 2.5" X 3.5 pilot door placard from the El
Cid interior that warns not to open cockpit door with the engine running???
They lost mine during rework...now I just have 4 screw holes in pilot door
interior panel.
Thanks,
Ken Hyde
**************Looking for a car that's sporty, fun and fits in your budget?
Read reviews on AOL Autos.
(http://autos.aol.com/cars-BMW-128-2008/expert-review?ncid=aolaut00050000000017 )
Message 6
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Volt/Amp meter |
Wow, what service and pointed too!
I'll check it out, thanks ever so much.
Tom...
----- Original Message -----
From: mike floyd
To: commander-list@matronics.com
Sent: Tuesday, August 12, 2008 10:48 AM
Subject: RE: Commander-List: Volt/Amp meter
Voltmeter fuse in the fuse block mounted in the master power panel has
a loose clip that holds the fuse in place.
-------------------------------------------------------------------------
-----
From: tfisher@commandergroup.bc.ca
To: commander-list@matronics.com
Subject: Commander-List: Volt/Amp meter
Date: Tue, 12 Aug 2008 09:38:31 -0700
I have a new snag, when I push the Volt/Amp button the needle goes
left instead of displaying the Volts.
Both Alternators are still putting out Voltage so it might be just the
gauge.
Any opinions?
Tom
C-GISS
680FLP (Mr.RPM)
----- Original Message -----
From: Robert Feldtman
To: commander-list@matronics.com
Sent: Tuesday, August 12, 2008 7:30 AM
Subject: Re: Commander-List: Another one bites the dust
dirty micro switch till proven otherwise - are your bungee cords
fresh?
bobf
On Tue, Aug 12, 2008 at 9:26 AM, Tommy Mathieu <tmathieu@msn.com>
wrote:
Gentlemen:
I am having a problem with a right main gear landing light. It has
become intermittent and the gear must be put down more than once to get
the light to stay illuminated. Any thoughts on what might be causing
this to occur. Our local shop looked at this but has not been able to
run down the problem. As always, I greatly appreciate any advice ya'll
can provide on the subject. I am learning as I go along.
Sincerely,
Tommy Mathieu
href="http://www.matronics.com/Navigator?Commander-List">http://www.mat
ronics.com/Navigator?Commander-List
href="http://forums.matronics.com">http://forums.matronics.com
href="http://www.matronics.com/contribution">http://www.matronics.com/c
st" target=_blank>http://www.matronics.com/Navigator?Commander-List
ttp://forums.matronics.com
=_blank>http://www.matronics.com/contribution
-------------------------------------------------------------------------
-----
Your PC, mobile phone, and online services8587394/direct/01/'
target='_new'>See how Windows=AE fits your life
Message 7
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Another one bites the dust |
My 560 has a similar problem - on the 560 gear the micro switch is
triggered by the down lock plunger gets gummed up with hydraulic fluid.
It eventually makes contact but on a delayed basis. All I've done is
clean it (replaced the metal diving board that activates the
micro-switch once) and it works just fine.
----- Original Message -----
From: Robert Feldtman
To: commander-list@matronics.com
Sent: Tuesday, August 12, 2008 10:30 AM
Subject: Re: Commander-List: Another one bites the dust
dirty micro switch till proven otherwise - are your bungee cords
fresh?
bobf
On Tue, Aug 12, 2008 at 9:26 AM, Tommy Mathieu <tmathieu@msn.com>
wrote:
Gentlemen:
I am having a problem with a right main gear landing light. It has
become intermittent and the gear must be put down more than once to get
the light to stay illuminated. Any thoughts on what might be causing
this to occur. Our local shop looked at this but has not been able to
run down the problem. As always, I greatly appreciate any advice ya'll
can provide on the subject. I am learning as I go along.
Sincerely,
Tommy Mathieu
Message 8
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: 500S Pilot Door Placard |
G&M nameplate co. in new rochelle,NY can make one for you. phone # 914 576 0408
On 8/12/08, KenWHyde@aol.com <KenWHyde@aol.com> wrote:
>
> Gentlemen!
>
> Anyone know where I can find the 2.5" X 3.5 pilot door placard from the El
> Cid interior that warns not to open cockpit door with the engine running???
> They lost mine during rework...now I just have 4 screw holes in pilot door
> interior panel.
>
> Thanks,
> Ken Hyde
>
>
> ________________________________
> Looking for a car that's sporty, fun and fits in your budget? Read reviews
> on AOL
> Autos.
> - The Commander-List Email Forum -
> Navigator to browse
> Un/Subscription,
> Photoshare, and much much more:
> http://www.matronics.com/Navigator?Commander-List
> - MATRONICS WEB FORUMS -
> Forums!
> http://forums.matronics.com
> - List Contribution Web Site -
> -Matt Dralle, List Admin.
> http://www.matronics.com/contribution
>
--
LLOYD
Message 9
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
The Fly-In is just around the corner and we're sure getting excited to see everyone.?
Just want to remind everyone that the deadline for getting the group rate
at the Marriott is August 28th so be sure to make your reservations.? Also
be sure to register with us for the Fly-In so we can give the caterers the proper
headcount.?
See You in Oklahoma City!!
Message 10
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Hi Jim,
I still want to make it to the fly-in, but I've had a rough start to my
week. Morris found that the case on my right engine is cracked...pretty
badly. So I have no airplane for the moment. Sadly this is my "new"
engine (800hrs. TTSO).
I'll know more by next week, in time to make the deadline.
Cheers,
/John
yourtcfg@aol.com wrote:
>
> The Fly-In is just around the corner and we're sure getting excited to
> see everyone. Just want to remind everyone that the deadline for
> getting the group rate at the Marriott is August 28th so be sure to
> make your reservations. Also be sure to register with us for the
> Fly-In so we can give the caterers the proper headcount.
>
> See You in Oklahoma City!!
> ------------------------------------------------------------------------
> It's time to go back to school! Get the latest trends and gadgets that
> make the grade on AOL Shopping
> <http://shopping.aol.com/back-to-school?ncid=aolins00050000000007>.
> *
>
>
> *
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|