Today's Message Index:
----------------------
1. 08:22 PM - Re: 0-200 mount (Randy L. Thwing)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
OK Deems:
I have a salvage 1970 150K in my backyard with the engine mount still
bolted to the firewall, I just went out with my Wife's help and measured
the engine mount bolts. Appreciate that this was at night, with a
Stanley tape measure, with my Wife holding the butt end. We checked
everything twice, so this is our best effort under these conditions.
Spacing horizontally, top and bottom = 29 1/8"
Spacing vertically, left and right = 24 1/4"
If you need more, just ask.
Regards,
Randy, Las Vegas
----- Original Message -----
From: Deems Herring
To: continental-list@matronics.com
Sent: Sunday, February 10, 2008 9:55 AM
Subject: Continental-List: 0-200 mount
I am making a test stand for an O-200. I have an engine mount from a
Cessna 150 that has some bent tubing. Can anyone tell me the distance
between the 4 mounting holes on the firewall so I can make a jig to hold
the mount to replace the tubes?
Deems
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|