Today's Message Index:
----------------------
1. 05:57 AM - Re: O200 Vacuum Pump cover (Tommy Walker)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: O200 Vacuum Pump cover |
Thanks Barry. I got lots of 0.125 and will fabricate me up one of the
plates.
On Tue, May 8, 2012 at 3:29 PM, FLYaDIVE <flyadive@gmail.com> wrote:
> Tom:
>
> Yes, there is an OFFICIAL plate but since you are experminental you could
> make your own. I would use 0.125" aluminum 6061 or 7075 with a gasket.
> And since you are sealing it almost permanently use a slight smear of Hi
> Temp RTV.
> NO - There aren't any gears to remove.
>
>
> Barry
>
> On Tue, May 8, 2012 at 12:57 PM, Tommy Walker <twalker@cableone.net>wrote:
>
>> twalker@cableone.net>
>>
>> I have an O200 with a vacuum pump. I don't plan to use any vacuum gauges
>> so I want to take it off to save weight. Is there a plate or cover that I
>> could get to seal off the engine. Also are there any gears or whatever
>> that need to be removed when the pump is taken off?
>>
>> Any help appreciated.
>>
>> Thanks,
>> Tommy Walker in Alabama
>> Building - Kitfox SS w/O200
>>
>> --------
>> Tommy Walker
>> N8701 - Anniston, AL
>>
>>
>>
>>
>> Read this topic online here:
>>
>> http://forums.matronics.com/viewtopic.php?p=372635#372635
>>
>>
>>
>>
>>
>>
>>
>> ==========
>> List" target="_blank">http://www.matronics.com/Navigator?Continental-List
>> ==========
>> http://forums.matronics.com
>> ==========
>> le, List Admin.
>> ="_blank">http://www.matronics.com/contribution
>> ==========
>>
>>
>>
>>
> *
>
> *
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|