Today's Message Index:
----------------------
1. 07:20 PM - Air Impact wrench (Pocono John)
2. 07:37 PM - Re: Tale of two Carbs (Ron Lendon)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Air Impact wrench |
Getting ready to disassemble a Corvair. I don't have any air tools/compressor.
It would cost close to $300 for a impact wrench, compressor and hose. Is it worth
it? Thanks!
--------
John
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=426613#426613
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Tale of two Carbs |
Today I was flying at 3000' and engine was leaned out to about 1350-1380 EGT at
2800 RPM. I pushed the throttle full and watched the EGT's go down to1200 without
moving anything but the throttle. OAT was 67F and all the other temps were
in the green, CHT 280-300, OT 220-230. I think things are looking pretty good
now that the engine is getting enough fuel.
--------
Ron Lendon
WW Corvair with Roy's Garage 5th bearing
CH 601 XLB
N601LT - Flying
http://www.mykitlog.com/rlendon
Corvair Engine Prints:
https://sites.google.com/site/corvairenginedata/
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=426614#426614
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|