Today's Message Index:
----------------------
1. 09:13 PM - Re: tail fold PVC "thing" dimensions (Jay Dub)
2. 09:26 PM - a few issues: wing gap seal velcro doesn't want to stick well and aileron u-joint seems sloppy (Jay Dub)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: tail fold PVC "thing" dimensions |
Thanks Larry,
I was able to get some PVC pipe and insulation today and made one. Seems to work
fine.
Jay
Sent:Saturday, May 13, 2023 at 7:32 AM
From:"Larry Cottrell" <lcottrell1020@gmail.com>
To:kolb-list@matronics.com
Subject:Re: Kolb-List: tail fold PVC "thing" dimensions
The one that I have is 41 inches overall length. It only needs to be
long enough to come down about half of the rudder and keep the
elevator and rudder from slapping around when folded.
Larry
On Fri, May 12, 2023 at 3:06PM Jay Dub <bearhawk@gmx.com> wrote:
>
>
>
> I'm not sure what to call the device that holds the hor. stab and elevator up
so one can fold the wings back. I'm looking to make one for my Firestar 2.
>
> In the plans it shows to make it with ropes and pipes. Does anyone have the dimensions
for making one that uses the pipe insulation on the pipes? I see on
the I could measure it all but was wondering if someone had the dimensions handy.
>
> Thanks,
> Jay
>
>
--
The older I get, the less tolerant I am of those who are intolerant of others.
If you forward this email, or any part of it, please remove my email
address before sending.
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | a few issues: wing gap seal velcro doesn't want to stick well |
and aileron u-joint seems sloppy
Two quick items I'm dealing with as I finish a new build:
I painted my plane with glossy paint. I put my velcro on the wings for the gap
seal but it doesn't seem to stick very well. I tried a sample of contact cement
but that didn't seem to do well either as it seems the glossy paint doesn't
have "teeth" to grab into. Any ideas how to deal with that other than making the
lexan hard gap seal or sanding down the paint?
My ailerons seem to have a lot of slop. Upon investigation the u-joint has slop
(not from the bolt holes but the u-joint itself) and the upper control rod ends
seem to have some slop too. Is this common with Kolb Firestars? Is this going
to cause a flutter problem? I do have the ailerons counterweighted and balanced
but I've never flown nor worked on an any plane with slop like this. It surprised
me being a new build and does make me wonder if this is going to create
any issues when I get to test fly.
Thanks,
Jay
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|