----------------------------------------------------------
                           Pietenpol-List Digest Archive
                                      ---
                     Total Messages Posted Fri 07/14/17: 3
           ----------------------------------------------------------
 
 
Today's Message Index:
----------------------
 
     1. 05:47 AM - Re: Working with sheet metal  (echobravo4)
     2. 06:42 AM - Re: Working with sheet metal  (Pocono John)
     3. 06:45 AM - Re: Dick Navratil's Rotec powered Piet  (charles mcfarland)
 
 
 
________________________________  Message 1  _____________________________________


Time: 05:47:27 AM PST US
Subject: Pietenpol-List: Re: Working with sheet metal
From: "echobravo4" 


Hi John

i cut out the blanks with a metal cutting bandsaw-
get the shapes close with the grinder, then draw file the edges and finish
with fine grade wet or dry sandpaper

--------
Earl Brown

I may not have gone where I intended to go, but I think I have ended up where I
intended to be.


Read this topic online here:

http://forums.matronics.com/viewtopic.php?p=470987#470987


________________________________  Message 2  _____________________________________


Time: 06:42:46 AM PST US
Subject: Pietenpol-List: Re: Working with sheet metal
From: "Pocono John" 


Thank you Tom , Bob and Earl. Got it.

JC

--------
John Cronin


Read this topic online here:

http://forums.matronics.com/viewtopic.php?p=470988#470988


________________________________  Message 3  _____________________________________


Time: 06:45:26 AM PST US
Subject: Pietenpol-List: Re: Dick Navratil's Rotec powered Piet
From: "charles mcfarland" 


Hi Dale,

Thanks for the reply and info.  I think you are talking about Aircraft Spruce when
you said AC&S?  I can send them a sample.  I have had lots of help thanks
to the forum and think there is a good possibility I can get a close match by
using one of several suggested techniques along with some trial and error work
on some junk pieces.

I will also try to call Aircraft Spruce just to see if they might have a record
of what Dick may have ordered years ago.  Probably a long shot, but you never
know.

Looking forward to Brodhead!

Charlie


Read this topic online here:

http://forums.matronics.com/viewtopic.php?p=470989#470989


 

-------------------------------------------------------------------------------------
                       Other Matronics Email List Services
-------------------------------------------------------------------------------------
Post A New Message               pietenpol-list@matronics.com
UN/SUBSCRIBE                     http://www.matronics.com/subscription
List FAQ                         http://www.matronics.com/FAQ/Pietenpol-List.htm
Web Forum Interface To Lists     http://forums.matronics.com
Matronics List Wiki              http://wiki.matronics.com
Full Archive Search Engine       http://www.matronics.com/search
7-Day List Browse                http://www.matronics.com/browse/pietenpol-list
Browse Digests                   http://www.matronics.com/digest/pietenpol-list
Browse Other Lists               http://www.matronics.com/browse
Live Online Chat!                http://www.matronics.com/chat
Archive Downloading              http://www.matronics.com/archives
Photo Share                      http://www.matronics.com/photoshare
Other Email Lists                http://www.matronics.com/emaillists
Contributions                    http://www.matronics.com/contribution
-------------------------------------------------------------------------------------

These Email List Services are sponsored solely by Matronics and through the 
generous Contributions of its members.