Today's Message Index:
----------------------
1. 10:12 AM - Matronics ISP Upgrade TODAY... (Matt Dralle)
2. 10:31 AM - Re: (Mark A. Wood)
3. 08:52 PM - Re: (Lee Thomas)
Message 1
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Matronics ISP Upgrade TODAY... |
--> Engines-List message posted by: Matt Dralle <dralle@matronics.com>
Dear Listers,
The time has finally arrived for the Internet Service Provider (ISP)
upgrade! You'll recall that I was looking into upgrading the existing SDSL
connection from 768k to 1.1M. As it turned out, the copper line wouldn't
support any speeds greater than the current 768k. In light of that news, I
just bit-the-bullet and ordered a full, commercial-grade T1
connection. The T1 connection will provide a full-duplex, high priority,
1.5Mb Internet connection which should be a substantial performance
enhancement for all of the List services!
Pacbell delivered the T1 Loop last week and it tested out fine. This past
weekend I pulled the tail circuit from the demark to the office. This
afternoon, Tuesday 4/1/03, the ISP is suppose come and install the new
router and bring up routing on a test subnet. Assuming that everything
checks out okay with the T1, new router, and routing, I will have them
swing the main Matronics subnet off the SDSL and onto the T1. In theory,
the swing could be nearly transparent to users, but that's usually not the
case... ;-)
Please expect a bit of instability in connectivity this afternoon as we
work though the transition issues. I will post a follow up message when
everything is up and running on the new T1 line.
Finally, please know that it is solely your Contributions that make these
kinds of List upgrades happen! There is no advertising budget (aka,
flashing banner ads and annoying pop up browser windows) to pay these
bills; operational support is solely from List members like you during the
yearly List Fund Raiser. If you would like to make your Contribution to
support the Lists and upgrades like this T1 connectivity enhancement,
please see the List Contribution Web Site where you can make your
Contribution with a Credit Card, PayPal, or Personal Check. You can even
get a free List Archive CDROM with a qualifying List Contribution! The URL
is: http://www.matronics.com/contribution
Thanks again to EVERYONE that made a generous Contribution last year and
enabled this awesome upgrade to T1 service!
Matt Dralle
Matronics Email List Admin.
Matt G Dralle | Matronics | PO Box 347 | Livermore | CA | 94551
925-606-1001 V | 925-606-6281 F | dralle@matronics.com Email
http://www.matronics.com/ WWW | Featuring Products For Aircraft
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: ngines-List: |
--> Engines-List message posted by: "Mark A. Wood" <Mark.Wood@uvm.edu>
From a friends Exec I know they make a good engine. I looked into the
purchase of one a few years ago from someone who had it sitting
around for the last ten years, but I couldn't get out to look at it
and was not going to buy something that had sat around for 10 years
without checking the condition. They get power at a higher RPM, 3100
I think, maybe up to-3500 I don't recall, This would call for a
smaller prop, so you would not want to use it in a STOL. The company
made 100 of the engines that were set up for use in tractor
configurations so I would assume that this is what you are looking
at. From what I have read they were a good engine. I called the
Rotaway factory and someone there had some info on them.
>--> Engines-List message posted by: Lee Thomas <cltvet@mail.ocis.net>
>
>Looking for information on the Rotaway RW100 engine.Has anyone used this
>engine in a tractor configuration? What is the recommended operating
>rpm's.Any spec's etc. would be appreciated.
>Lee
>
--
Mark Wood
Center on Disability and Community Inclusion
University of Vermont
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: ngines-List: |
--> Engines-List message posted by: Lee Thomas <cltvet@mail.ocis.net>
Thanks for the reply on the RW100.
Lee
At 01:30 PM 01/04/03 -0500, you wrote:
>--> Engines-List message posted by: "Mark A. Wood" <Mark.Wood@uvm.edu>
>
> From a friends Exec I know they make a good engine. I looked into the
>purchase of one a few years ago from someone who had it sitting
>around for the last ten years, but I couldn't get out to look at it
>and was not going to buy something that had sat around for 10 years
>without checking the condition. They get power at a higher RPM, 3100
>I think, maybe up to-3500 I don't recall, This would call for a
>smaller prop, so you would not want to use it in a STOL. The company
>made 100 of the engines that were set up for use in tractor
>configurations so I would assume that this is what you are looking
>at. From what I have read they were a good engine. I called the
>Rotaway factory and someone there had some info on them.
>
> >--> Engines-List message posted by: Lee Thomas <cltvet@mail.ocis.net>
> >
> >Looking for information on the Rotaway RW100 engine.Has anyone used this
> >engine in a tractor configuration? What is the recommended operating
> >rpm's.Any spec's etc. would be appreciated.
> >Lee
> >
>
>--
>Mark Wood
>Center on Disability and Community Inclusion
>University of Vermont
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|