----------------------------------------------------------
                           Engines-List Digest Archive
                                      ---
                     Total Messages Posted Sun 04/20/03: 2
           ----------------------------------------------------------
 
 
Today's Message Index:
----------------------
 
     1. 05:35 PM - missing bolt.  (Brian Huffaker)
     2. 06:05 PM - Re: missing bolt. tests=SPAM_PHRASE_00_01,USER_AGENT_PINE  (Terry Watson)
 
 
 
________________________________  Message 1  _____________________________________


Time: 05:35:28 PM PST US
From: Brian Huffaker <bifft@xmission.com>
Subject: Engines-List: missing bolt.
        tests=SPAM_PHRASE_00_01,USER_AGENT_PINE

--> Engines-List message posted by: Brian Huffaker <bifft@xmission.com>


  When preflighting the starduster today, I found that the bolt that
attaches the arm to you to set the alternator belt tension to the engine
was missing.  This is on an Lycoming HIO-360.  It goes into the crankcase,
and my rough measurements (no proper measurement tools at the airport)
have the hole as about 1/2" and 3/4" deep.  Does anybody know the size
bolt I need to fix this, and where I can get one?

  Brian Huffaker, DSWL (bifft@xmission.com)
  RV-8A 80091 installing control column mounts.
  1/4 Starduster II N23UT flying






________________________________  Message 2  _____________________________________


Time: 06:05:07 PM PST US
From: "Terry Watson" <terry@tcwatson.com>
Subject: RE: Engines-List: missing bolt.        tests=SPAM_PHRASE_00_01,USER_AGENT_PINE

--> Engines-List message posted by: "Terry Watson" <terry@tcwatson.com>

Brian,

From my 60 amp alternator installation drawing from Vans, that would be a
HEX 5-16 18X1 DH BOLT (drilled head)

Terry
RV-8A #80729


-----Original Message-----
  When preflighting the starduster today, I found that the bolt that
attaches the arm to you to set the alternator belt tension to the engine
was missing.  This is on an Lycoming HIO-360.  It goes into the crankcase,
and my rough measurements (no proper measurement tools at the airport)
have the hole as about 1/2" and 3/4" deep.  Does anybody know the size
bolt I need to fix this, and where I can get one?

  Brian Huffaker, DSWL (bifft@xmission.com)
  RV-8A 80091 installing control column mounts.