Today's Message Index:
----------------------
1. 10:21 AM - Rear Prop Gov. Questions (Hopperdhh@aol.com)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Rear Prop Gov. Questions |
I searched the archives, but couldn't find answers to these questions.
I am thinking of putting an IO-360-A1A engine in my RV-7A. It has been
flying with an IO-360-A1D6 which has a front mounted governor.
Could someone on the list please tell me approximately what the thickness of
the rear mounted prop governor adapter pad is on an IO-360-A1A? I have an
old one that measures about 2 1/16 inches. Is there a thinner one available?
The dimension I need is from the accessory case to the prop governor itself.
Also, will the McCauley governor off the left front of my IO-360-A1D6 work
on the rear of the -A1A? As far as I can tell there is about 3 percent
difference in the drive ratio -- 0.866 vs 0.895. I would assume that the governor
could be adjusted for this difference. Is there some other reason why it
won't work?
Thanks,
Dan Hopper
RV-7A
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|