----------------------------------------------------------
                           Engines-List Digest Archive
                                      ---
                     Total Messages Posted Sun 04/29/07: 2
           ----------------------------------------------------------
 
 
Today's Message Index:
----------------------
 
     1. 04:04 PM - Engine Lord Mounts  (Speedy11@aol.com)
     2. 04:18 PM - Re: Engine Lord Mounts  (Grant Piper)
 
 
 
________________________________  Message 1  _____________________________________


Time: 04:04:32 PM PST US
From: Speedy11@aol.com
Subject: Engines-List: Engine Lord Mounts

I bought the Van's Lord mount kit for my IO-390 (same dimensions as  IO-360).
For anyone who's installed their engine, to what value did you torque the  
7/16 engine mounting bolts?
Did you use 475 inch pounds?  Did you use coarse thread torque or fine  
thread?
Thanks,
Stan Sutterfield


************************************** See what's free at http://www.aol.com.

________________________________  Message 2  _____________________________________


Time: 04:18:54 PM PST US
From: "Grant Piper" <grant.piper@bigpond.com>
Subject: Re: Engines-List: Engine Lord Mounts

Hi Stan,

You will have trouble getting a torque wrench onto these bolts, and it 
may be of limited use.   The rubber mounts must be compressed such that 
the bolt is tight on the inner spacer (this limits the amount of 
compression).   The compression of the rubber will add to your torque 
reading also.   I've only installed a couple of enginmes, but in each 
case did the bolts up tight on the spacer then as required to get the 
cotter pins in.

regards,

Grant
  ----- Original Message ----- 
  From: Speedy11@aol.com 
  To: engines-list@matronics.com 
  Sent: Monday, April 30, 2007 9:03 AM
  Subject: Engines-List: Engine Lord Mounts


  I bought the Van's Lord mount kit for my IO-390 (same dimensions as 
IO-360).
  For anyone who's installed their engine, to what value did you torque 
the 7/16 engine mounting bolts?
  Did you use 475 inch pounds?  Did you use coarse thread torque or fine 
thread?
  Thanks,
  Stan Sutterfield


-------------------------------------------------------------------------
-----
  See what's free at AOL.com. 


 

-------------------------------------------------------------------------------------
                       Other Matronics Email List Services
-------------------------------------------------------------------------------------
Post A New Message               engines-list@matronics.com
UN/SUBSCRIBE                     http://www.matronics.com/subscription
List FAQ                         http://www.matronics.com/FAQ/Engines-List.htm
Web Forum Interface To Lists     http://forums.matronics.com
Matronics List Wiki              http://wiki.matronics.com
Full Archive Search Engine       http://www.matronics.com/search
7-Day List Browse                http://www.matronics.com/browse/engines-list
Browse Digests                   http://www.matronics.com/digest/engines-list
Browse Other Lists               http://www.matronics.com/browse
Live Online Chat!                http://www.matronics.com/chat
Archive Downloading              http://www.matronics.com/archives
Photo Share                      http://www.matronics.com/photoshare
Other Email Lists                http://www.matronics.com/emaillists
Contributions                    http://www.matronics.com/contribution
-------------------------------------------------------------------------------------

These Email List Services are sponsored solely by Matronics and through the 
generous Contributions of its members.