Engines-List Digest Archive
Tue 05/17/11 |
Total Messages Posted: 1 |
Today's Message Index:
----------------------
1. 08:19 PM - Re: Carburetor stud removal (turbot)
Message 1
INDEX Back to Main INDEX NEXT Skip to NEXT Message LIST Reply to LIST Regarding this Message SENDER Reply to SENDER Regarding this Message
Time: 08:19:48 PM PST US
Subject: Re: Carburetor stud removal
From: "turbot" <turbot@shaw.ca>
try the double nut trick again.
tighten the 2 nuts against each other, hard, put a washer in between if you like.
Then put wrench in INSIDE ( case side ) nut & screw stud out.
You will easily get enough grip to snap the stud off, without nuts slipping !
if you think an open end wrench will just round off the inside nut, trap an closed
end wrench under the washer on assembly.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=340226#340226
Other Matronics Email List Services
Post A New Message engines-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/Engines-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com 7-Day List Browse http://www.matronics.com/browse/engines-list Browse Engines-List Digests http://www.matronics.com/digest/engines-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.