Today's Message Index:
----------------------
1. 05:16 AM - Re: locator beacon (Richard Iddon)
2. 05:33 AM - panel and inserts (josok)
3. 07:45 AM - PLB Registration (Richard Iddon)
4. 11:20 AM - Swiss trip (Richard Iddon)
5. 12:32 PM - Wednesday DOTH? (Bryan Allsop)
6. 12:49 PM - Re: PLB Registration (Duncan McFadyean)
7. 04:00 PM - Re: panel and inserts (N55XS)
8. 04:00 PM - Re: panel and inserts (Kingsley Hurst)
9. 09:18 PM - Re: panel and inserts (Fergus Kyle)
10. 09:44 PM - Re: panel and inserts (Cliff Shaw)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
--> Europa-List message posted by: "Richard Iddon" <riddon@sent.com>
Thanks Mike, a useful article.
As you say, officially it is only for maritime use. However, I phoned
the maritime base for registering the unit and they were quite happy for
me to register it with them. Also I note now that Adams aviation are
offering the same unit (for 446 pounds, I paid 299 at a chandelery).
They tell me that for aviation the unit should be registered with RAF
Kinloss so I have sent them an email and am awaiting their reply.
As the unit is registered to a person rather than a specific vessel I
can't see any problem. I shall take it with me and will certainly not
hesitate to deploy it if the need arises, whether on land or water. I
can always argue the toss later.
Richard Iddon G-RIXS
--> Europa-List message posted by: "Mike Parkin"
<mikenjulie.parkin@btinternet.com>
Richard,
I found this page - <http://www.seathree.demon.co.uk/plb/plb-3.html>
which
may be of interest.
The pertinent part is the following extract I think.
UK. 406 PLBs are legal in the UK - but only for maritime use.
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | panel and inserts |
1.64 REPLY_TO_EMPTY Reply-To: is empty
0.10 TO_EMPTY To: is empty
--> Europa-List message posted by: "josok" <josok-e@ukolo.fi>
Is it a very bad idea to bond the panel in, and keep the inserts as removable sub-panels?
Could i use camloc type hardware for it?
Regards,
Jos Okhuijsen
----------------
Visit EuropaOwnersForum http://www.europaowners.org/
Message 3
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | PLB Registration |
--> Europa-List message posted by: "Richard Iddon" <riddon@sent.com>
RAF Kinloss confirmed that there is no problem using the PLB in an
aircraft and, as I have registered the unit with the maritime
authorities, I do not need to register it with them also.
Richard Iddon G-RIXS
Do not archive
Message 4
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
--> Europa-List message posted by: "Richard Iddon" <riddon@sent.com>
It is possible I may have a spare seat for the Swiss trip. I am
planning to leave Blackpool Wednesday am and overnight in Guernsey
before joining up with the rest of the team in Poitiers for lunch on
Thursday.
Please contact me off forum if interested.
Richard Iddon G-RIXS
Do not archive
Message 5
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
--> Europa-List message posted by: "Bryan Allsop" <bryan@blackballclub.com>
Hi Paddy and all.
You suggested that you would fancy another doth on Wednesday. I am up for it if
you are. The weather man is saying that it should be good. It looks poor thereafter,
with a suggestion that it could be a week or so before settled weather
returns.
I await your suggestions.
Cheers.
Bryan. Do not archive
Message 6
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: PLB Registration |
--> Europa-List message posted by: "Duncan McFadyean" <ami@mcfadyean.freeserve.co.uk>
I suppose the document at
http://www.cospas-sarsat.org/DocumentsGSeries/g5oct30.pdf
describes the different protocols betwix marine and aviation; I couldn't be
bothered to read it all, but couldn't see a good practical reason that would
preclude a boat owner using his beacon in a small light aircraft! Although
SAR may have difficulty in believing there was a distressed yacht in
Switzerland.
Duncan Mcf.
----- Original Message -----
From: "Richard Iddon" <riddon@sent.com>
Subject: Europa-List: PLB Registration
> --> Europa-List message posted by: "Richard Iddon" <riddon@sent.com>
>
> RAF Kinloss confirmed that there is no problem using the PLB in an
> aircraft and, as I have registered the unit with the maritime
> authorities, I do not need to register it with them also.
>
> Richard Iddon G-RIXS
>
> Do not archive
>
>
>
Message 7
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: panel and inserts |
--> Europa-List message posted by: N55XS <topglock@cox.net>
Jos,
While I didn't bond my panel, I am using sub panels. They are attached
using standard anchor nuts and AN screws, like those provided with the
kit. Works just fine...
Jeff
N55XS - 9.6 hrs left to fly off...
josok wrote:
>--> Europa-List message posted by: "josok" <josok-e@ukolo.fi>
>
>Is it a very bad idea to bond the panel in, and keep the inserts as removable
sub-panels? Could i use camloc type hardware for it?
>
>Regards,
>
>Jos Okhuijsen
>----------------
>Visit EuropaOwnersForum http://www.europaowners.org/
>
>
>
>
Message 8
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | panel and inserts |
--> Europa-List message posted by: "Kingsley Hurst" <hurstkr@growzone.com.au>
> Is it a very bad idea to bond the panel in, and keep the inserts as
removable sub-panels? Could i use camloc type hardware for it?
Jos,
Are you aware of the Europa Club Mod for holding the Panel in ? If not,
I suggest you have a look at it because it is an excellent idea IMO.
Makes it very easy to install and remove. (when there is no wires
connected that is !)
Regards
Kingsley in Oz.
Message 9
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: panel and inserts |
--> Europa-List message posted by: "Fergus Kyle" <VE3LVO@rac.ca>
----- Original Message -----
From: "Kingsley Hurst" <hurstkr@growzone.com.au>
Subject: RE: Europa-List: panel and inserts
> Is it a very bad idea to bond the panel in, and keep the inserts as
| removable sub-panels? Could i use camloc type hardware for it?
| Jos,
| Are you aware of the Europa Club Mod for holding the Panel in ? If not,
| I suggest you have a look at it because it is an excellent idea IMO.
| Makes it very easy to install and remove. (when there is no wires
| connected that is !) Regards Kingsley in Oz.
Jos,
I second the notion. The mod puts the bolts fixed to the inside of the panel
forward through the firewall with the mounting nuts in the engine
compartment. This allows the whole panel to slide back and (thanks to Nigel)
is a real advantage for maintenance or major revision.
Ferg
A064
Message 10
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: panel and inserts |
--> Europa-List message posted by: "Cliff Shaw" <flyinggpa@comcast.net>
Jos
I bonded my panel (custom made) in and then make each side from plate removable.
All the wiring is going through round cannon plugs. I can take the pilot side
out in 7 minutes, you can time me !
I like it this way. There has been several time I needed to do work in behind,
and out it came. Easy. I used #6 screws with the nutplates bonded in to fasten
it in.
Cliff Shaw
1041 Euclid ave.
Edmonds, WA 98020
425 776 5555
http://www.europaowners.org/WileE
----- Original Message -----
From: josok
Sent: Monday, August 15, 2005 5:32 AM
Subject: Europa-List: panel and inserts
--> Europa-List message posted by: "josok" <josok-e@ukolo.fi>
Is it a very bad idea to bond the panel in, and keep the inserts as removable
sub-panels? Could i use camloc type hardware for it?
Regards,
Jos Okhuijsen
----------------
Visit EuropaOwnersForum http://www.europaowners.org/
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|