Today's Message Index:
----------------------
1. 02:42 AM - Autopilot installation (G-IANI)
2. 05:24 AM - Re: Autopilot installation (Jeremy Davey)
3. 05:39 AM - Re: Autopilot installation (G-IANI)
4. 08:32 AM - Spinner for Arplast PV50 (David Steade)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Autopilot installation |
There is a lot of interest in the Dynon autopilot at the moment. While we
have many examples of the roll servo installation I have never seen any
details of a pitch servo setup.
Has anyone done this and could they let me have some details and or
pictures.
Ian Rickard G-IANI XS Trigear, 200 hours
Europa Club Mods Rep (Trigear)
e-mail mods@europaclub.org.uk
or direct g-iani@ntlworld.com
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Autopilot installation |
Ian,
It's only under construction, and therefore not an LAA-approved mod yet, but
mine has the roll-servo mostly installed, including the crank onto the
control system.
Regards,
Jeremy
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of G-IANI
Sent: 02 December 2008 10:41
Subject: Europa-List: Autopilot installation
There is a lot of interest in the Dynon autopilot at the moment. While we
have many examples of the roll servo installation I have never seen any
details of a pitch servo setup.
Has anyone done this and could they let me have some details and or
pictures.
Ian Rickard G-IANI XS Trigear, 200 hours
Europa Club Mods Rep (Trigear)
e-mail mods@europaclub.org.uk
or direct g-iani@ntlworld.com
Message 3
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Autopilot installation |
Jeremy
Thanks do you have any pictures or other details of the location?
Ian Rickard G-IANI XS Trigear, 200 hours
Europa Club Mods Rep (Trigear)
e-mail mods@europaclub.org.uk
or direct g-iani@ntlworld.com
Message 4
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Spinner for Arplast PV50 |
Hi All
I'm thinking of fitting an Arplast PV50 propeller to my XS trigear.
Does anyone know if the standard factory 10 inch spinner will fit with
this propeller or would it be best to use the standard Arplast spinner
which is only about 9 1/2 inches in diameter?
Any advice would be appreciated.
Regards
David Steade
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|