Today's Message Index:
----------------------
1. 01:10 AM - Re: Europa-List Digest: 24 Msgs - 03/09/09 (D Wysong)
2. 03:13 AM - Re: software (David Joyce)
3. 03:22 AM - Re: software (G-IANI)
4. 04:51 AM - Re: Flap position, Flight testing (Kingsley Hurst)
5. 05:02 AM - Re: Re: Europa-List Digest: 24 Msgs - 03/09/09 (Robert Borger)
6. 06:53 AM - Re: Flap position, Flight testing (ALAN YERLY)
7. 09:21 AM - EuropaOwners is Moving (SteveD)
8. 09:50 AM - Reply soon (Karel Vranken)
9. 11:16 AM - Re: software (Paul Stewart)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Europa-List Digest: 24 Msgs - 03/09/09 |
> It is my belief that the turbo flange will be too hot (especially after
> shut down) for silicone hoses. Silicone is OK for water cooling system
> only? However I suggest you check this out don't rely on my authority.
Howdy Bob,
Perhaps these silicone hoses are a different animal. Per the FAQ
(www.turbohoses.com), these are good to over 1000 F in one hour
increments and 600 F continuously per their FAQ. Our extended 914
ground runs haven't revealed any heat issues thus far but we'll
certainly keep an eye on things. :-)
D
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Paul, You can download the 3 different versions (each for a different range
of engine nos) from the Rotax website. Regards, David Joyce, G-XSDJ
----- Original Message -----
From: "Paul Stewart" <europa@pstewart.f2s.com>
Sent: Monday, March 09, 2009 7:00 PM
Subject: Europa-List: software
>
> Anyone know where I can get a copy of the throttle setting software for
> the 914?
>
> Paul
> G-GIDY
>
>
>
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Both the Factory and the Europa Club have available copies of the 914
throttle setting software. The software is small and I can e-mail it to
you. There are three versions and, depending on age of engine, you may need
a "dongle". The Factory has a "dongle" but the club does not. You may also
need to make up a suitable cable for connection to a PC.
You can contact me (on 01483 714096) if you wish to discuss further.
Ian Rickard G-IANI XS Trigear, 250 hours
Europa Club Mods Rep (Trigear)
e-mail mods@europaclub.org.uk
or direct g-iani@ntlworld.com
Message 4
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Flap position, Flight testing |
Alan,
Thank you for your write-up on flight testing and trimming.
Mostly understood but in one place you said "Right flap down rolls
right." . . . . did you mean to say this ??
Cheers
Kingsley in Oz.
Message 5
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Europa-List Digest: 24 Msgs - 03/09/09 |
Bob & D,
I have silicone hose (different vendor) on the compressor out side of
my my intercooled 914. A total of 4 hours running. Half on the
ground and half actual flight time. No issues so far.
Check six,
Bob Borger
Europa Kit #A221 N914XL, XS Mono, Intercooled 914, Airmaster C/S
http://www.europaowners.org/N914XL
Aircraft Flying!
3705 Lynchburg Dr.
Corinth, TX 76208
Home: 940-497-2123
Cel: 817-992-1117
On Mar 10, 2009, at 3:01, D Wysong wrote:
>
>> It is my belief that the turbo flange will be too hot (especially
>> after
>> shut down) for silicone hoses. Silicone is OK for water cooling
>> system
>> only? However I suggest you check this out don't rely on my
>> authority.
>
> Howdy Bob,
>
> Perhaps these silicone hoses are a different animal. Per the FAQ
> (www.turbohoses.com), these are good to over 1000 F in one hour
> increments and 600 F continuously per their FAQ. Our extended 914
> ground runs haven't revealed any heat issues thus far but we'll
> certainly keep an eye on things. :-)
>
> D
>
>
Message 6
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Flap position, Flight testing |
Many thanks,
My brevity of my checklist is not always clear.
I mean that to cure a tendency of the aircraft to roll to the right, you
correct with a droop of the right flap when trimming.
Thanks for putting up with my hurried post.
Bud Yerly
Custom Flight Creations
----- Original Message -----
From: Kingsley Hurst<mailto:hurstkr@redzone.com.au>
To: europa-list@matronics.com<mailto:europa-list@matronics.com>
Sent: Tuesday, March 10, 2009 7:45 AM
Subject: Re: Europa-List: Flap position, Flight testing
Alan,
Thank you for your write-up on flight testing and trimming.
Mostly understood but in one place you said "Right flap down rolls
right." . . . . did you mean to say this ??
Cheers
Kingsley in Oz.
http://www.matronics.com/Navigator?Europa-List<http://www.matronics.com/N
avigator?Europa-List>
http://www.matronics.com/contribution<http://www.matronics.com/contributi
on>
Message 7
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | EuropaOwners is Moving |
Hello all,
EuropaOwners is moving in both the real and virtual worlds. Over the next month
the location of the servers that EuropaOwners lives on are moving to a new location.
Then once the servers are physically moved the servers themselves will
be upgraded. So, in a perfect world you would never know the difference. In the
real world you may see blips in service durning the next month or so. Please
let me know of any loss of service, but don't worry we will be back...
Thanks,
Steved
Visit - www.EuropaOwners.org
Message 8
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
To all,
Since more than ten years I was a user of Hotmail. Not only the spam invaded
my PC but also my account was shut down. So meanwhile you are thinking that
I am laying under a palm tree in Lagos as a certain Fowler. But I was unable
to repair the communication with my ancient server. Here is my new adress:
karelvranken9@gmail.com and back on the list again.
Best regards,
Karel Vranken.
Message 9
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Thanks to all who have helped out with the software.
Paul
G-GIDY
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|