Today's Message Index:
----------------------
1. 01:06 AM - Very Good News 1.2 Bar Radiator cap (philip george)
2. 05:23 AM - Re: Europa Monowheel Brake Problem? (Kevin Klinefelter)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Very Good News 1.2 Bar Radiator cap |
Having done some research and trawling the net how to save money on 1.2 bar
radiator cap . How about =A316.92 delivered to your door!!! and this the
correct part as fitted to BMW F650 motor cycle makes sense i think. The pa
rt number is 19409 and sold by BMW parts suppliers . Try www.motobins.co.u
k usual disclaimer i have no link with this company. this makes a saving o
f about =A340!! the cap even comes with a manufacturers date code stamped
on the top. I hope this is of use to every one to keep the cost of flying d
own .
Philip George G
-EORJ xs mono
_________________________________________________________________
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Europa Monowheel Brake Problem? |
Hi Jeff,
My mono-wheel brake was leaking a bit of fluid and not holding pressure
well. Turned out to be the O-ring seal. We removed the brake from the
disc and used a rubber tipped compressed air gun to push the "puck" out
of the slave cylinder. Then we saw the o-ring to replace. It looked
like it was leaking from the bleed screw simply because the bleed screw
is the lowest point to drip from.
When the mono is sitting tail down the master cylinder in the tunnel is
at an angle with the filler low. I needed to raise the tail (or unmount
the master cyl) to get the air out.
Messy job eh?
Kevin
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|