Today's Message Index:
----------------------
1. 03:38 PM - Re: flap drive pin engagement (JR Gowing)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | flap drive pin engagement |
Thank you Dave!
Yes it is on my "to do" list and I have not mounted the wings since the
service bulleting was issued!
No I won't lose the list!
JR (Bob) Gowing UK Kit 327 in Oz
Do not archive
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of david park
Sent: Friday, 11 March 2011 10:45 PM
Subject: RE: Europa-List: flap drive pin engagement
Bob,
Someone else has quoted the SB No. I changed mine during build when I had
to adjust length of cross tube.
Dave
_____
From: jrgowing@bigpond.net.au
Subject: RE: Europa-List: flap drive pin engagement
David Park
Would you please quote what Service Bulletin No refers, and your kit
number so we can see if this concerns other builders?
JR (bob) Gowing Kit no 327 in Oz
Do not archive
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of david park
Sent: Wednesday, 9 March 2011 1:37 AM
Subject: RE: Europa-List: flap drive pin engagement
Replaced my bearing housings with heat gun, and turned bearing with mole and
levered with screwdriver on edge - no problem.
Dave G-LDVO
> Subject: Europa-List: flap drive pin engagement
> From: keesdebussy@hotmail.com
> Date: Tue, 8 Mar 2011 05:07:30 -0800
> To: europa-list@matronics.com
>
<keesdebussy@hotmail.com>
>
> In my case the flap drive pins engagement comply with the service bulletin
on that matter but at the portside it is at the limit. So I decide the bring
it well within the limits and I purchased the special bearing housing from
Europa Aircraft.
>
> I have now a problem to remove the original housing and bearing from the
x-tube. The x-tube end was heated with a hot air gun (air of 600 degr. C /
1110 degr. F) but I could not get any movement of the bearing housing.
>
> Has anybody experience in removeing the bearing housing from the X-tube ?
Any ideas are welcome.
>
> Kees de Bussy
> PH-SBR
>
>
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=333147#333147
>
>
>
>
>
>===============
>
>
>
http://www.matronics.com/Navigator?Europa-List
http://forums.matronics.com
http://www.matronics.com/contribution
_____
No virus found in this message.
Checked by AVG - www.avg.com <http://www.avg.com/>
Version: 10.0.1204 / 03/09/11
target=_blank>http://www.matronics.com/Navigator?Europa-List
ttp://forums.matronics.com
=_blank>http://www.matronics.com/contribution
_____
No virus found in this message.
Checked by AVG - www.avg.com
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|